Pinball 2000 Monitor
Just bought a RFM and wondered what was the best monitor and the easiest to
install.My current monitor works fine but is a little dark, I turned the
brightness and contrast up all the way but still is not what it should be.
How much of a risk is it to turn up the brightness on the flyback
transformer? Could it cause problems with my current working setup? Any
help would be greatly appreciated...thx
.
Relevant Pages
- Re: Pictures taken at Woking and Horsham (England) shows
... proper calibration requires hardware as well as software. ... test-prints at a shop near my home and I found that the shop's prints were just a tad on the dark side. ... So basically I turned down the brightness of my monitor a bit, now it works great - until the lab changes their settings :-( ...
(rec.models.railroad) - Re: Sony Trinitron CPD-100ES
... Great monitor, perfect color, just the right sharpness, everything is ... I've got the brightness up to full, and it's still far too dark. ... There should be a brightness control inside the monitor. ...
(sci.electronics.repair) - Re: Sony Trinitron CPD-100ES
... Great monitor, perfect color, just the right sharpness, everything is ... I've got the brightness up to full, and it's still far too dark. ... I'm not familiar with this particular monitor, ...
(sci.electronics.repair) - Sony Trinitron CPD-100ES
... I have a monitor here, I've had it for probably about 4 years now. ... Great monitor, perfect color, just the right sharpness, everything is ... I've got the brightness up to full, and it's still far too dark. ...
(sci.electronics.repair) - Tech: P2K Monitor?
... On my RFM ... I am having issues with the brightness. ... monitor is cold, then after it warms up everything is washed out. ...
(rec.games.pinball) |
|
