Re: Stern Seawitch Fuse Question

Any voltage fuse will work for the feature lamps- they are 6vdc. Usually
most fuses of the type used are 32v at the minimum available rating. Many
are 120v. Some are 240v. So any will work as they're higher voltage than
the application.

Ray J.
--
Action Pinball & Amusement, LLC
Salt Lake City, Utah USA
Web: www.actionpinball.com

We're serious about pinball. Anything else is just for fun!



<davideis@xxxxxxxxx> wrote in message
news:1132686395.323175.11770@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Thank you. I was incorrect when I said the GI lights. The problem is
> with the Feature Lamps F1.
> I know it is a 10 Amp Fuse but I am not sure what the Voltage should be
> on that fuse.
> Thanks for all your help.
>
> David eisner
>


.

Relevant Pages

  • Re: HELP! Onan Emerald III No AC
    ... I replaced the fuse and let it sit for a minute. ... motor purrs along just fine and does not blow the fuse. ... I applied the load and the surging was ... 'transformer regulated' set - no electronic voltage regulator. ...
    (rec.outdoors.rv-travel)
  • Re: 120 to 12v conversion
    ... Also I would like to place a fuse on the 120VAC side of the power ... find a regulated power supply for that voltage with the full rated ... I guess I failed to mention the LED lights came with a wall wart ... CSA approvals/numbers and if it's a digital switching supply, ...
    (alt.home.repair)
  • Re: Scary Tingling
    ... breaker or blow a fuse, ... measure any voltage on it is in the 1/2 second or so from the time the hot ... Since it didn't trip a breaker ...
    (rec.outdoors.rv-travel)
  • Re: UL & fuse rating
    ... I've just finished designing a new switching power supply. ... The fuse I've selected is a 5mm pigtail, 1.5amp fast action rated at 250V. ... Here is an excerpt from webpage about the voltage rating: ...
    (sci.electronics.design)
  • Re: Pioneer SX-737 No FM
    ... a cap to gnd between b+ and this pin. ... concerned about the amount of voltage I see on pin 11 of the IC. ... F1 and F2 fuse one of the pairs of wires coming off of the ... Remove Q4 from the circuit and test ...
    (sci.electronics.repair)
Loading