Re: Tech: Transformer connector part number

Series 1292p, 1292r, 3191p, and 3191r are the ones you're looking for. One of

19-09-2099 (plug), 19-09-1099 (recept w/latch), or 03-09-2092

is *probably* what you need. Plug the series numbers into Molex' Web site,
select the 9-position units, and go from there.

Joseph "Tony" Dziedzic

In article <mo2dnYG-0c9HI8reRVn-uw@xxxxxxxxxxx>, "Jim Knight"
<rottendogNOSPAM@xxxxxxxxxxx> wrote:
>Did a Google to no avail........
>
>Anyone know what series or, better yet, the 9-pin connector part number that
>was used on most late model / WMS transformers? This is the connector on
>the 110/220V side.
>
>I measure the spacing to be 0.25" across pin centers, and in looking through
>the web site for Molex, I can not find this connector anywhere.
>
>Thanks in advance
>Jim Knight
>Remove NOSPAM from direct email responses.
>
>
.

Relevant Pages

  • Re: M4 power issue
    ... I check the wires from the switch to the power ... With the molex connectors off ... So I checked the voltage at the end of the black connector to the video ... Again only about 1 to 1.5 volts. ...
    (comp.sys.tandy)
  • Re: Why dont camera reviews cover the data connection to the PC?
    ... downloaded it and the manual and the web site call the port a USB/AV port. ... Yes, I'd responded, before reading your message, concerning the manual. ... NOTHING about what the connector was. ...
    (rec.photo.digital)
  • Re: Why dont camera reviews cover the data connection to the PC?
    ... downloaded it and the manual and the web site call the port a USB/AV port. ... reading the manual wouldn't have helped me just as reading the ... NOTHING about what the connector was. ...
    (rec.photo.digital)
  • Re: Is this part repairable (A-20605) 9 light board
    ... should I replace the connector? ... If the molex connector housing is ... pins inside the housing. ...
    (rec.games.pinball)
  • Re: 4 pin molex replacement?
    ... The Molex connector is likely to remain a standard for some time, ... aggravated the volt drop issue by almost doubling the volt drop that ... it turned out to be the actual crimp contact resistance ...
    (uk.comp.homebuilt)
Loading