Re: DOH!!

I sugguested in news:kd9ka2d132gh0m3vp4jvtdt3823pr0v39f@xxxxxxx:
--> dishwasher powder now in block form <--

Do you have a drill and a wide-bladed drillbit? A few minutes with the
drill will free up enough to use as necessary. Do powder the whole
thing; it'll just resolidify. DO NOT use the bottle as a mallet again.
You're lucky it didn't shatter in your hand.

<sigh> The mind will add words to sentences to give the meaning that
was _supposed_ to be there and when seen missing the meaning that was
intended isn't even close to the meaning that's there now.

"Do powder" should read, "Do not powder." With it as wet as it is,
you'll quickly end up with another solid block of soap.

So PeterL <inbrissie@xxxxxxx> followed up with:
Are you the Danger Ranger?

If so, you'll either die, or have a very long career around me ;-)

Death is so overrated. A spectacular death just means everyone, not
just family and close friends, get to mock your last moment of "Hey
y'all! Lookit me!"

The Ranger
.

Relevant Pages

  • Re: kokoro ga komotte
    ... out, but I never got to like it (her new accent-marking system drove me nuts), or I should say I disliked it more. ... I had spent a lot of time figuring out how to make BJ drills meaningful; ... For the record, just to be pedantic, "Spoken Japanese" is the 1940's ... It just seemed to me that they were nonsense as written--they were, or could too easily be for all but the most motivated student--sounds divorced from meaning. ...
    (sci.lang.japan)
  • Arc Fault Circuit Interrupters
    ... One of them plugged a big drill into an outdoor outlet, ... He used a squeaker to nose around, and discovered that ALL FIVE AFCIs in the breaker panel appear to be defective. ... Defective meaning that no power comes out of the AFCI, no matter how he fiddles with test button, reset button, and breaker on-off handle. ... Are these things more sensitive to lightning surges than GFCIs, of which there are several in the house? ...
    (sci.electronics.repair)
  • Re: Metal powders for filling UK
    ... to recover blanks and other pieces of wood with gaps, ... The problem I noticed was price of the powder ... I just chuck a piece of brass bar in my lathe and use a file to get small stuff, or put a drill bit in the tailstock and drill into the end to get crumbles. ... Hors d'oeuvres--a ham sandwich cut ...
    (rec.crafts.woodturning)
  • Re: kokoro ga komotte
    ... pedagogy per se. ... It just seemed to me that they were nonsense as ... get the meaning back in and still drill the forms. ... I wish I had appreciated drill work back then the way I do now. ...
    (sci.lang.japan)
  • Re: Drill Press problems
    ... I think your bits came from the same place as the drill press. ... make powder and smoke, ...
    (rec.woodworking)