Re: Segmented Cookie Dish for Santa



Yeah, that sounds about right.  I've put about 2-3x more into
accessories than the lathe.

If that is true, it is time to buy a new lathe. It is important to maintain a balance in your expenditures!
.




Relevant Pages

  • Re: DVR XP
    ... As for your current lathe... ... 360 degree radius to balance loads on the chuck/spindle. ... Eurowood Werks Woodturning Studio, The Woodlands, Texas ... rpm on my Jet seems like 1,000 on the outer edge.. ...
    (rec.crafts.woodturning)
  • Re: DVR XP
    ... I could have dug up about $3,000 to get a DVR and accessories, or $3,200 to have ... As for your current lathe... ... 360 degree radius to balance loads on the chuck/spindle. ... Eurowood Werks Woodturning Studio, The Woodlands, Texas ...
    (rec.crafts.woodturning)
  • Re: Clearing out Dads workshop - still ongoing!!
    ... It was a Perris PL100 lathe of 1960s vintage. ... of accessories - like 3 jaw, 4 jaw, large set of collets, vertical ... We valued the lathe and all its accessories at £200. ...
    (uk.rec.models.engineering)
  • Re: Wood Lath Question
    ... Out of balance situations happen (before or after ... They are bigger problem at a a higher diameter. ... Once again, be smarter than the lathe, and balance your turnings. ...
    (rec.woodworking)
  • Re: Are spindle adapters safe?
    ... a larger lathe, I have never felt the urge to put a chuck back on my Nova ... try to put faceplates on adapters just because they are so cheap (plug for ... mandrels and small accessories are 1/8 and I hate to have ...
    (rec.crafts.woodturning)