Re: more home wiring: where's my neutral?

Neutral is probably up in the light fixture. It is perfectly acceptable to run the hot and neutral to the light fixture, then run a hot and switched hot to the light switch. Ground wires tended to get ignored when running to a switch only. Not the best but it was often done.

If you dig around and find a neutral, it is unclear if you would find the correct neutral. It might work if you found a different neutral but the loads would be unbalanced. Not to mention unsafe if you wanted to work on the OTHER circuit.

Joe Pfeiffer wrote:
I've got a 25 year old house, whose light switches I'm converting over
to a powerline protocol called INSTEON (see www.smarthome.com; for
purposes of this question, it's very similar to the old X10 protocol).

Two of the bedrooms are on one circuit breaker (the whole rooms:
lights, outlets, the whole shebang). Each room has a single switch
controlling the lights in that room. I pulled a light switch out this
evening, planning to replace it, when I saw there was no neutral in the
junction box (the INSTEON switches require both hot and neutral). At
first I expected to find neutral in the wall behind the box (I was
guessing they had, for some reason, routed hot through the box and to
the switch while leaving neutral unbroken), but then realized that what
went in the box was a single piece of three-conductor wire, with black
used for hot, white for switched, and ground not connected.

So... before I start digging the junction box out, what are my odds of
finding neutral somewhere in the vicinity? More generally, I'm having a
hard time imagining why someone would wire the ceiling light fixture and
not have power and neutral come from the same place! So, before I get
myself in trouble, how did they likely wire it?

Thanks in advance,
.

Relevant Pages

  • Re: Installing a ceiling fan
    ... then You are probably only dealing with a Hot and 2 Switch ... Many times electricians will wire up the Power Feed to the Light/Fan and Run ... Neutral in the Junction box even though there is a White. ... I connected the other ends to the fan wires ...
    (alt.home.repair)
  • Re: Is This Wiring Plan Possible?
    ... Run wire from source, to light fixture #1, then to light fixture #2, and finally to two wall switches in a box at the end of the run. ... Is it possible to control each light fixture with its own switch, ... Connect the black wire from the source to the white wire of the cable that goes to the switches. ... Mark that white wire with tape or magic marker at both ends some color other than white, gray, or green. ...
    (alt.home.repair)
  • Re: Help with a electrical wiring problem
    ... >I need help figuring out how to wire an outdoor electrical circuit. ... Into the same junction box I have ... >switch box with two light switches. ...
    (alt.home.repair)
  • Re: Help with a electrical wiring problem
    ... >>I need help figuring out how to wire an outdoor electrical circuit. ... Into the same junction box I have ... >>switch box with two light switches. ...
    (alt.home.repair)
  • Re: Small wiring puzzle
    ... I'm replacing a light and the switch that controlled it. ... and a white wire connected to it, and the black one is hot. ... I'm thinking that there is another junction box somewhere where these ...
    (alt.home.repair)
Loading