Re: Abene mill gearbox insides
- From: "Bill Noble" <nobody@xxxxxxxxxxxxxxx>
- Date: Sun, 16 Nov 2008 23:22:29 -0800
"Winston" <Winston@xxxxxxxxxxxxxx> wrote in message
news:gfpret0n06@xxxxxxxxxxxxxxxxxxxx
Larry Jaques wrote:
On Sat, 15 Nov 2008 23:29:41 -0800, the infamous Winston
<Winston@xxxxxxxxxxxxxx> scrawled the following:
Bill Noble wrote:
(...)
If anyone would like, I can take a couple of photos of the assembledPlease do.
gearbox
ready to go back into the mill and upload them to the drop box - I
won't
bother unless someone asks.
For the lazy old guys, please provide a link, ala:
http://www.metalworking.com/dropbox/Abene_VHF-3-Gear-2.JPG
What's with the brass/bronze, non-hypoid, non-helical, curve-toothed
gear thingy, Unca (Aunt?) Winnie?
That's _Honorary Aunt_ to you, buster.
The worm wheel? I haven't the foggiest.
Hey Bill, can you remind us what the worm wheel does for a living?
Thank you kindly.
--HA Winnie
There are two brass pieces in the gear box - at the top is a brass gear that
is driven by a worm gear (that goes into the rear housing) - the worm is
driven by a 2 hp motor, in my case via a flat belt.
The other brass (bronze?) piece is the sifter fork, that moves two gears up
and down based on the rotating of the gear sleector lever. Thsi is a 12
speed gearbox, as I recall.
.
- Follow-Ups:
- Re: Abene mill gearbox insides
- From: Larry Jaques
- Re: Abene mill gearbox insides
- References:
- Abene mill gearbox insides
- From: Bill Noble
- Re: Abene mill gearbox insides
- From: DoN. Nichols
- Re: Abene mill gearbox insides
- From: Bill Noble
- Re: Abene mill gearbox insides
- From: Winston
- Re: Abene mill gearbox insides
- From: Larry Jaques
- Re: Abene mill gearbox insides
- From: Winston
- Abene mill gearbox insides
- Prev by Date: Re: Abene mill gearbox insides
- Next by Date: Re: AR15 evaluation
- Previous by thread: Re: Abene mill gearbox insides
- Next by thread: Re: Abene mill gearbox insides
- Index(es):
Relevant Pages
|