Any 5C adaptor that could fit this?

Won this on ebay. This backplate should fit my lathe. It did not cost
much, so I am sure that I can use it for various purposes, whatever
they might be.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=190239479425

And my question is, how hard is it to find a 5C collet adaptor/chuck
that would fit this, perhaps with some machining. I am not sure what
is the exact name of the thing that I would be looking for. "plain
back 5C chuck" or something?

--
Due to extreme spam originating from Google Groups, and their inattention
to spammers, I and many others block all articles originating
from Google Groups. If you want your postings to be seen by
more readers you will need to find a different means of
posting on Usenet.
http://improve-usenet.org/
.

Relevant Pages

  • Re: Ebay stuff...what do I with with em?
    ... And emailing them is like pissing into the wind. ... Due to extreme spam originating from Google Groups, ... If you want your postings to be seen by ...
    (rec.crafts.metalworking)
  • Re: Obamas landslide?
    ... and reducing budget deficit by increasing taxes. ... Due to extreme spam originating from Google Groups, ... If you want your postings to be seen by ...
    (rec.crafts.metalworking)
  • Re: Welding one of the worst occupations, according to WSJ
    ... If I remember the article right, they rated it by how physically hard ... Due to extreme spam originating from Google Groups, ... If you want your postings to be seen by ...
    (sci.engr.joining.welding)
  • Re: best way to weld together two 1/4" lead sheets?
    ... The backing plate would address melt-through nicely. ... Due to extreme spam originating from Google Groups, ... If you want your postings to be seen by ...
    (rec.crafts.metalworking)
  • Re: Bench grinder motor for Ig
    ... Due to extreme spam originating from Google Groups, ... If you want your postings to be seen by ... I called GE about warrantee information and was informed that the ...
    (rec.crafts.metalworking)