Re: Cutting fluid?
Roger Paskell wrote:
I have just purchased a new 7X12 metal cutting bandsaw, and I can't seem to
find any good information about what cutting fluid or coolant to use.
Roger
If you're limited to what Ace Hardware sells,
use pipe threading lubricant for steel and
WD-40 for aluminum. I've found that aluminum
will sometimes cut better dry depending on
the length of the cut and alloy.
.
Relevant Pages
- Re: Bin Forgotten and his 19 boxcutters
... not produce ''molten steel". ... I mentioned that rust and molten aluminum produce molten ... That's hot enough to initiate the thermite reaction when ... Please name a single incidence where fire caused ...
(rec.music.classical.guitar) - Re: Steel hull and aluminum superstructure
... and i don't have electrical connectivity between the superstructure and ... Bolt and aluminum flatbar to it and then build the ... I would build the whole boat out of aluminum. ... welded to the aluminum side and the steel to the steel side. ...
(rec.boats.building) - Re: Steel hull and aluminum superstructure
... You would have plenty of electrical connection through the bolts. ... Bolt and aluminum flatbar to it and then ... I would build the whole boat out of aluminum. ... The aluminum is welded to the aluminum side and the steel to the ...
(rec.boats.building) - Re: Steel hull and aluminum superstructure
... have electrical connectivity between the superstructure and the hull? ... Bolt and aluminum flatbar to it and then build the ... I would build the whole boat out of aluminum. ... welded to the aluminum side and the steel to the steel side. ...
(rec.boats.building) - Re: Surly Karate Monkey
... he'll claim that aluminum is great and steel is crap. ... aluminum allows stiff frames without the weight penalty. ... among my "normal" bikes. ...
(rec.bicycles.tech) |
|
