Re: Guitar neck slots ?


<tdudley@xxxxxxxxxxxx> wrote: (clip) Does anyone
have any tips as to how this could be repaired ? (clip)
^^^^^^^^^^^^^^^^^^^^
Look at the possibility of pressing in filler bars which contrast with the
aluminum in such a way that they become an attractive design. Does the neck
have those round marker disks at certain intervals? Maybe you could match
them. Or use wood that matches the guitar body. Or an ebony colored
material. Or a combination. Sit down with a sketch pad and see what you
come up with.


.

Relevant Pages

  • Re: How to fabricate drip-tray...
    ... >>>Pressing them out as you describe would be expensive for so few. ... >>>would be to shear them out of aluminum sheet, notch the corners, fold the ... >> Too bad they have to be so thick - foil trays come in many sizes. ... aluminum and a few minutes of CNC machine time for each ...
    (rec.crafts.metalworking)
  • Re: Strength of aircraft grade versus 6061 aluminum?
    ... Planning to use a short piece of 5/8" outer diameter ... Pressing down on the center of the tube will be a maximum momentary ... Is there any difference between 6061 aluminum and aircraft grade ...
    (rec.crafts.metalworking)
  • How to change brightness and contrast of a bitmap?
    ... to let the user change the brightness and contrast of the image by ... pressing the 5-way key......i have searched the msdn help but it seem ...
    (microsoft.public.windowsce.platbuilder)
  • Re: CRIT: Proposed opening of WIP
    ... Brian M. Scott wrote: ... way, but in contrast to the other two, especially the ... police station one, where I was pressing back into my ...
    (rec.arts.sf.composition)