Re: Oh boy...

Tell them each hole should have a wire-brushed surface using a new
Stainless Knot-type brush.

I'll have him call you. :)
--


Regards,
Joe Agro, Jr.
(800) 871-5022
01.908.542.0244
Automatic / Pneumatic Drills: http://www.AutoDrill.com
Multiple Spindle Drills: http://www.Multi-Drill.com

V8013-R



.

Relevant Pages

  • Re: Its a Metal Engine - On Topic Then, Right?
    ... Joseph Gwinn wrote: ... Joe Agro, Jr. ... Automatic / Pneumatic Drills: http://www.AutoDrill.com ... Multiple Spindle Drills: http://www.Multi-Drill.com ...
    (rec.crafts.metalworking)
  • Re: Feed Controls?
    ... The catch is that I need the cylinder to be small. ... Joe Agro, Jr. ... Automatic / Pneumatic Drills: http://www.AutoDrill.com ... Multiple Spindle Drills: http://www.Multi-Drill.com ...
    (rec.crafts.metalworking)
  • Re: Rotary Table ???
    ... Not if they're on a hill and not anchored to the floor ... Joe Agro, Jr. ... Automatic / Pneumatic Drills: http://www.AutoDrill.com ... Multiple Spindle Drills: http://www.Multi-Drill.com ...
    (rec.crafts.metalworking)
  • Re: Sodium Silicate - engine killer...
    ... At least not after they run "sand" through 'em. ... Joe Agro, Jr. ... Automatic / Pneumatic Drills: http://www.AutoDrill.com ... Multiple Spindle Drills: http://www.Multi-Drill.com ...
    (rec.crafts.metalworking)
  • Re: Know Someone in NJ That Needs a Job? The Ex govenor?
    ... Very funny... ... Joe Agro, Jr. ... Automatic / Pneumatic Drills: http://www.AutoDrill.com ... Multiple Spindle Drills: http://www.Multi-Drill.com ...
    (rec.crafts.metalworking)