Re: Desoldering question (Miller XMT welder repair)



Ignoramus19508 wrote:
I do indeed like its temp control and other features. I have it set at
950 degrees.

I will now look for accessories for it.
Ouch, that's real high. If I was wanting to repair the PC board (rather than salvaging the
chips) I would stay below 800. I often run it at 750.

If you get good heat transfer at 950 the traces will come off the boards for sure.

Jon

.

Relevant Pages

  • Re: Well and truly knackered!
    ... wince. ... Friend's MZ that came in for repair: ... MZs are not made of thin metal. ... Ouch, but have you seen the one of Floyd's RF900? ...
    (uk.rec.motorcycles)
  • Re: A tad annoyed
    ... Coolant leak turned out not to be an incorrectly fitted hose after ... Ouch, that's a fucker. ... you're agreeing to the repair on a without prejudice basis. ...
    (uk.rec.motorcycles)
  • Gibson ES345TD (prob. 74) value?
    ... I've had someone bring a Gibson 9stereo) ES-345 TD into my shop, wanting it ... The repair was simple enough, ... I mostly deal with classical and flamenco guitars. ...
    (alt.guitar)
  • Re: RISC Microprocessor...
    ... > here is an image of the actual damage, ouch! ... you may be able to repair it with a dental pic and ... air rework station. ...
    (sci.electronics.repair)
  • Re: A tad annoyed
    ... Ouch, that's a fucker. ... you're agreeing to the repair on a without prejudice basis. ... the bike later. ...
    (uk.rec.motorcycles)