Re: How to measure pulley diameter

Thank you Bob, very useful answer.
For some mysterious reason neither my OP nor your response appear on my news
reader.

Mauro



"Grant Erwin" <grant@xxxxxxxxxxxxxxxxxx> wrote in message
news:13dges59crje9be@xxxxxxxxxxxxxxxxxxxxx
Bob Engelhardt wrote:

To measure the blade's pulley "pitch diameter": make a chalk mark on the
pulley and belt just where the belt "exits" the pulley, rotate the pulley
one revolution so the belt's chalk mark moves away from the pulley, and
measure the distance on the belt from its chalk mark to the pulley's
chalk mark. This is the pitch circumference, divide by pi for the pitch
diameter.

Buy a new pulley whose pitch diameter is twice this. Pulleys *are* sold
by pitch diameter. Maybe not the ones on the rack at Ace Hardware, but
the ones at MSC, McM-C, etc.

Bob, that is a very clever trick, and one I never thought of when I had
this problem!

I actually disagree with you about pulleys being sold by PD, though. If I
go into my local Ace and measure the OD of what they sell as a 5" pulley,
it will read 5" and it will be made by Chicago Die Casting. If I order a
3/4" bore 5" pulley from MSC it will also be made by Chicago Die Casting
and it will also measure 5" across the OD. And it may well have 1/32" of
runout both radially and axially. I've bought and returned pulleys from
MSC.

Maybe if you step up to Browning, Morse, don't know.

It is possible to take such a pulley and mount it by its bore in a lathe
and true it up. I did this when I replaced a Shopsmith drive pulley awhile
ago and the trued up el cheapo zinc pulley runs dead true.

Grant


.

Relevant Pages

  • Re: Archer Air?
    ... In order to make room for the alternator belt plus the A/C belt on the pulley bulkhead and still maintain the engine/belt pulley/prop geometry, Piper "borrowed" some room from the alternator belt. ... It is a whopping 1/4 inch piece of spaghetti that breaks anywhere from 1 hour to 150 hours, depending on alignment, tension, and the condition of the pulleys. ...
    (rec.aviation.owning)
  • Re: Mobile base
    ... I have a link belt hanging on the wall for when I need a belt change... ... chuck to use it on my 1442. ... happened is that I broke off the little stops on the pulley. ... items provided you use the white plastic washer. ...
    (rec.crafts.woodturning)
  • Re: Removing Timing Drive Pulley, 93 Civic
    ... I'm trying to get to the one on the crank. ... you'll probably need to replace the belt guide by this stage. ... if it's not leaking bad enough to contaminate the timing belt, there's no real harm from a little leakage, and maybe it can be contained as above. ... it very simply states to remove the timing drive pulley. ...
    (rec.autos.makers.honda)
  • Re: VFD and bandsaw success
    ... The saw label says it's a wood/metal cutting saw. ... the belt and pulley combination set up for the lowest RPM and the VFD ... You'd probably lose the ability to change speeds with the belt but then ...
    (rec.crafts.metalworking)
  • Re: help with newly acquired lathe
    ... was SO glad when the taper popped out without very much tapping. ... headstock and pull the motor towards you to slack the belt to change it. ... pulley, with the belts running up -- as the machine was designed to use ...
    (rec.crafts.metalworking)