Re: Notching Aluminum Tubing
On Aug 30, 3:39 pm, dan *5 <MrDanMand...@xxxxxxxxx> wrote:
...
The cut is very ragged, and I'm assuming this is caused by either the
drilling speed, the lack of rigidity, or the hole saw itself. ...
I've used the white Home Depot hole saws on the lathe and mill, which
are much more rigid than a drill press, and also gotten a ragged cut.
jw
.
Relevant Pages
- Re: Spooky Action At a Distance Question
... > meter diameter hole. ... > appear shortened in the frame of the hole and fall through. ... But it does because 'rigidity' is not ... > piece of a painting the points would appear to be random. ...
(sci.physics.research) - Re: Drilling a BIG hole at 40 deg...
... If you blank a round hole first, normal to the sheet's surface, smaller than ... If the drillpress gives you fits, you can do the same thing with the lathe. ... peck drill the hole with a standard hole saw. ... You should expect the last cut or two to be impacted by machine rigidity, ...
(rec.crafts.metalworking) - Re: Spooky Action At a Distance Question
... >> On the question of rigidity in special relativity Taylor and Wheeler have ... >> meter diameter hole. ... >> appear shortened in the frame of the hole and fall through. ...
(sci.physics.research) - Re: Drilling question...
... to prop up the 260 pound plate the the height of the base table of the ... If you do use the hole saw, ... Make the die holder first so you can use its holes as a template to ... drill press head and continue. ...
(rec.crafts.metalworking) - Re: How to control/reduce speed of drill press
... with motors with brushes - my drill press is a 1/3 hp induction motor ... I've looked at the pulley sets, and the one over the motor looks like ... Concerning the depth of hole, I'll be drilling hard maple or baltic ...
(rec.woodworking) |
|
