Re: QX for Gunner

On Tue, 31 Jul 2007 13:26:30 -0400 in rec.crafts.metalworking, "Lloyd E.
Sponenburgh" <lloydsp@xxxxxxxxxxxxxx> wrote,
I'm wondering if the pin end needs to be sharpened up a bit to increase
penetration into the rim, then shorten the boss if necessary.

You don't want penetration of the rim. You don't want it sharp.
You want crushing of part of the rim.


.

Relevant Pages

  • Re: QX for Gunner
    ... You don't want penetration of the rim. ... that only works if the firing pin can't rotate. ... The chisel shape gives good crushing impacts even with a weak hit. ...
    (rec.crafts.metalworking)
  • Found in bank roll--2005 Jefferson error??
    ... It is much thinner than normal and ... the rim is sharp. ... I suspect it could be just some kind of after mint ...
    (rec.collecting.coins)
  • Re: Is this someting I sould be concerned about?
    ... i believe it protects the tube from the rim, so as long as your rim is ... nice and not bumpy or sharp, i dont think it should be too crazy, maybe ...
    (rec.sport.unicycling)