Re: Using cyanoacrylate (super glue) to fix cuts in the workshop
- From: Don Bruder <dakidd@xxxxxxxxx>
- Date: Mon, 26 Jun 2006 10:49:18 -0700
In article <Xns97EE7A3CDA000someconundrum@xxxxxxxxxxxxxx>,
Richard J Kinch <kinch@xxxxxxxxxxx> wrote:
TMN writes:
There are probably very good reasons why you should not do this.
Ordinary CA glue has a methyl portion that the medical type does not. So
the common stuff while curing is more toxic to live tissue. In small dabs
this doesn't seem to be a problem for most people.
For this particular "most people", that's definitely true. YMMV, I'm
quite sure. I've never tried it for a wound that required more than a
literal "single drop" application, so "high dose" issues have never come
up for me.
It works to cover and soothe open cuts with new "skin", but as a mechanical
closure it does not maintain a bond for long enough to replace suturing.
I'll dispute that based on empirical evidence, personally collected. See
my other post in this thread. The gauze wrap I mentioned in it came off
in the night, and was never replaced, since the oozing it was intended
to absorb had ceased by the time I woke up the next morning.
It typically sheds in a day or so, and you need at least 3 or 4 days for
wound closure.
I've had zero issues with wound re-opening.
Granted, this is only one case, however, I've used it several times for
similar wounds, all with equal success, even over joints. (the hardest
test of *ANY* wound-closure method, be it bandaging, suturing, or
whatever else)
The key is a *CLEAN* (no jagged/torn edges) slice-type wound such as a
sharp blade or broken plate glass would give you. Any sort of "rip" type
wound, on the other hand, is a bad candidate for such treatment, and
likely needs to see a doctor for at least suturing, if not debridement
THEN suturing.
--
Don Bruder - dakidd@xxxxxxxxx - If your "From:" address isn't on my whitelist,
or the subject of the message doesn't contain the exact text "PopperAndShadow"
somewhere, any message sent to this address will go in the garbage without my
ever knowing it arrived. Sorry... <http://www.sonic.net/~dakidd> for more info
.
- References:
- Using cyanoacrylate (super glue) to fix cuts in the workshop
- From: TMN
- Re: Using cyanoacrylate (super glue) to fix cuts in the workshop
- From: Richard J Kinch
- Using cyanoacrylate (super glue) to fix cuts in the workshop
- Prev by Date: Re: My dogs are eating aluminium swarf !!!
- Next by Date: Re: Shrink wrapping a pallet ?
- Previous by thread: Re: Using cyanoacrylate (super glue) to fix cuts in the workshop
- Next by thread: Re: Using cyanoacrylate (super glue) to fix cuts in the workshop
- Index(es):
Relevant Pages
|