Re: Cone drawing program?

From: Larry Jaques <novalidaddress@di\/ersify.com>
Date: Thu, 08 Jun 2006 19:41:49 -0700

On Thu, 08 Jun 2006 03:47:48 GMT, with neither quill nor qualm, Gary
Brady <gourdhedd@xxxxxxxxxxxxxxxxxxxxxxx> quickly quoth:

Ken Finney wrote:

I need a program that I can enter the dimensions (small diameter, large
diameter, length) of a hollow cone (like a megaphone) into, and it will
print out the pattern necessary to make it out of *** stock. Does such a
thing exist? Cheap?

Not cheap, free: http://www.pulserate.com/

Gary, that's -not- free software, it's $29 Shareware. Please support
Shareware authors. They're good and hardworking folks like us.

---
- Friends don't let friends use FrontPage -
http://diversify.com Dynamic Website Programming
.

Follow-Ups:
- Re: Cone drawing program?
  - From: Gary Brady

References:
- Cone drawing program?
  - From: Ken Finney
- Re: Cone drawing program?
  - From: Gary Brady

Prev by Date: Re: Copper wire from copper rods
Next by Date: Re: casting sand on Extreme Engineering Wednesday night.
Previous by thread: Re: Cone drawing program?
Next by thread: Re: Cone drawing program?
Index(es):
- Date
- Thread