Re: Stitch/Spot welding questions

I hope you're not replacing a 10 megohm potentiometer with a
50K ohm one and no series resistance.

While extending the pots to the front panel might work in
theory, you're doing it in a very noisy environment. It
might induce noise that will affect your timing. Those pots
need to be very close to the circuit board.

Eric R Snow wrote:
The Pause time pot is a 10 megohm and the
Pulse is a 50k ohm device. Since the Pause pot has so much more
resistance it is very hard to finely adjust. I will be replacing it
with a 50k pot. In fact, I am going to replace both pots because the
ones in the kit are trimmer pots and I want the adjustment knobs on
the front of the welder.
.

Relevant Pages

  • Re: GA20-RVT - Tube voltages
    ... Gibson and replaced all of the blob caps. ... It is very weird that the pots control nothing. ... When replacing parts, do one part at a time and then power up the amp to ...
    (alt.guitar.amps)
  • GA20-RVT
    ... Gibson and replaced all of the blob caps. ... It is very weird that the pots control nothing. ... When replacing parts, do one part at a time and then power up the amp to ...
    (alt.guitar.amps)
  • Re: GA20-RVT - Tube voltages
    ... Gibson and replaced all of the blob caps. ... It is very weird that the pots control nothing. ... When replacing parts, do one part at a time and then power up the amp to ...
    (alt.guitar.amps)
  • Re: GA20-RVT
    ... Gibson and replaced all of the blob caps. ... It is very weird that the pots control nothing. ... When replacing parts, do one part at a time and then power up the amp to ...
    (alt.guitar.amps)
  • Re: sound issue - system 9
    ... If the volume pots and the speaker are ok usually one MC1458 op amp on the speech ... >>I have a Williams Sorcerer systems 9 game. ... >>test via the diagnostics, you cannot hear the sounds unless my ear is right ... >>I have not yet started replacing any components. ...
    (rec.games.pinball)