Re: 1 VFD--2 Motors can it be done?


"Gunner" <gunner@xxxxxxxxxxxxxx> wrote in message
news:5md752p7tpjg0dm26nadqhmt55oi4keh65@xxxxxxxxxx
On Fri, 28 Apr 2006 09:37:47 -0400, "AndrewV"
<AndrewV@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx> wrote:

Of course maybe I'll get lucky and find a step pulley with a 7/8's center.

Make one. Making your own pulleys is not rocket science. Its rather
easy in fact.

Mark well, then use a cut off tool to slit down the exact center of
each groove, then set and lock your compound and slide, and the apron
and go in with a tripan tool. Do all the right sides or left sides in
each groove, then turn the compound and slide and do all the opposite
sides. Takes longer to discuss than actually do. Well..pretty close
anyways. <G>

Gunner

I'd gladly take a stab at making my own pulley's, the only problem is that I
don't have a lathe yet.
Hopefully I'll remedy that soon.

Enjoy

Andrew


--
NewsGuy.Com 30Gb $9.95 Carry Forward and On Demand Bandwidth
.

Relevant Pages

  • Re: 1 VFD--2 Motors can it be done?
    ... each groove, then set and lock your compound and slide, and the apron ... "I think this is because of your belief in biological Marxism. ...
    (rec.crafts.metalworking)
  • Re: Clausing 1301 Cross top slide Part 2
    ... Not too much of a surprise for a 1973 lathe, ... slide, compound base, lower cross slide etc. ... ie milling off the slots to accept a compound base. ... top of the lower cross slide for me to mill this area flat.... ...
    (rec.crafts.metalworking)
  • How to shellac/poly the inside 5 sides of drawers (with a sliding bottom)
    ... I've got a never used Purdy 3" natural brush and could use shellac, ... got to finish the inside 5 sides of eight drawers. ... then slide it in finished? ... in the groove. ...
    (rec.woodworking)
  • Re: Drawer Slides?
    ... what's the chance you could dado or grooove the drawer ... >sides themselves to create a groove for the side slide to go into, ...
    (rec.outdoors.rv-travel)
  • Re: Clausing 1301 Cross top slide Part 2
    ... Not too much of a surprise for a 1973 lathe, ... slide, compound base, lower cross slide etc. ... ie milling off the slots to accept a compound base. ... top of the lower cross slide for me to mill this area flat.... ...
    (rec.crafts.metalworking)
Loading