Re: What are the best Aloris quick-change holders to start out with?

I forgot to include #77 Cut-Off and Grooving Holder in my comparison
request. I'm just curious of #71 or #77 end up being better tools that
#7 AND cheaper to run because you just need to replace the carbide
cut-off inserts rather than the whole blade.

.

Relevant Pages

  • Re: Toolpost rocking with cheap two bolt mount
    ... reducing speed from 750rpm to 150rpm, and resetting the height of the blade, things worked MUCH better, But as it got close to cut-off, it grabbed a bit and the whole toolpost, compound slide, and clamp ring ROCKED towards the workpiece... ... The compound of these was a bit flexible, but it would still smash a cutoff blade or rip the work ...
    (rec.crafts.metalworking)
  • Re: DW705 explosion
    ... and the cut-off? ... Todd the wood junkie wrote: ... saw blade had bent the rear blade guard, broken the vacuum attachment, ... I fear the shaft is also bent. ...
    (rec.woodworking)
  • Toolpost rocking with cheap two bolt mount
    ... I was making a cut-off last night with my Aloris AXA-77. ... After reducing speed from 750rpm to 150rpm, and resetting the height of the blade, things worked MUCH better, But as it got close to cut-off, it grabbed a bit and the whole toolpost, compound slide, and clamp ring ROCKED towards the workpiece... ...
    (rec.crafts.metalworking)