Re: bench grinder wheel replacement?

From: "Tom Gardner" <tom(nospam)@ohiobrush.com>
Date: Sun, 23 Apr 2006 22:36:50 GMT

" Jim Sehr" <Jimatcf@xxxxxxxxxx> wrote in message
news:444bfdd1_2@xxxxxxxxxxxxxxxxxxxxx

I hand tighten then take a long box wench on the nut and slap the far end
of same with another wench. I have been doing this for over 50 years and
have had fellow workers
say I tighten them too much. It is the slap that does it and it works for
me.
Jim

What size is the other wrench?

.

Follow-Ups:
- Re: bench grinder wheel replacement?
  - From: Jim Sehr

References:
- bench grinder wheel replacement?
  - From: Grant Erwin

Prev by Date: Re: Brake cylinder sleeving
Next by Date: Re: bench grinder wheel replacement?
Previous by thread: bench grinder wheel replacement?
Next by thread: Re: bench grinder wheel replacement?
Index(es):
- Date
- Thread

Relevant Pages

Re: bench grinder wheel replacement?
... If the nut takes a 3/4 box wrench I use the next size larger or smaller ... of same with another wench. ... It is the slap that does it and it works for ...
(rec.crafts.metalworking)
Re: How to select a relay for short, very high currents?
... The finer details of english spelling ... ...
(sci.electronics.design)
Re: j"g 對抗不景氣 j"g
... I said beam me down a WRENCH, ... not a WENCH! ... KIRK OUT!" ...
(comp.security.firewalls)
Re: David Hansen?
... Probably with another wrench. ... It must be a /very/ frustrating job. ... I parsed that as "probably with another wench", ... undercover dibbles have to find their own. ...
(uk.railway)
Re: How to select a relay for short, very high currents?
... So what is wrong with the wench? ... (remove 'x' and 'invalid' when replying by email) ...
(sci.electronics.design)