Re: Need help finding a supplier...

Hobbit:

The general process for design is to first establish the standard sizes
of the material, bearings, fasteners, tubes, pipes, hoses, motors,
gears, gear boxes, etc. etc. that you are likely to need.

This will make your design much less costly and time consuming to
implement.

Only if standard or preferred size will absolutely not suffice should
custom sizes be considered. Even here it is preferrable to modify
standard-sized components.

This is particularly important for items such as tubing, piping,
ball/roller bearings, bar stock, gears, etc.

I would first review my design to ensure that the above conditions have
been met.

Hobbit wrote:
> I am trying to find a supplier who can supply 316L stainless in the
> following sizes:

.

Relevant Pages

  • Re: Making Gear Cutters (Ivan Laws Book)
    ... Mr. Law sets out two tables of design information for the cutters, one 20deg pressure angle and the other is at 30deg pressure angle. ... Too be honest it's a bit of an armchair question as I've had a kind offer from one of the guys on the group to cut the two gears I'm after, but can't abide leaving things I don't understand to one side! ... To obtain actual sizes then either divide by the DP of the actual gear to get sizes in inches or multiply by the module to get sizes in millimeters. ... Another is that the tables often give dimensions for a cutter intended to cover a range of gears. ...
    (uk.rec.models.engineering)
  • Re: Target market for Intellasys.
    ... I would like to see a full speed general purpose embedded serial interconnect IO bus standard. ... Looking through serial memory I found something like a maximum of 70mhz speed which is pretty useless if it was the only bus in a cutting edge design. ... All other control mode levels also have this ability, to allow developer to instigate their own versions of the features not defined in that level, as they wish, if they wish. ...
    (comp.lang.forth)
  • Re: gets(); was: Re: Why does rewind() ignore errors?
    ... useful as any other input function standard C delivers. ... Ever programmed a big system havin about 300 little applications as ... There can be a simple stream whoes source is somewhere on the world ... Programming starts with design. ...
    (comp.std.c)
  • Re: Interface standards (was Re: Dual Port RAM)
    ... I find there lack of a standard on the 'internal' side to be ... principle of abstraction; instead of hiding complex functions behind ... simple interfaces, ... write the code for because it is just a sub-function of the overall design. ...
    (comp.arch.fpga)
  • Re: Interface usage best practices
    ... since he definitely did have those low level features ... The dynamics of the physical elements of the design. ... But neither his notation nor UML address the last. ... > in the standard so that they are no longer extensions. ...
    (comp.object)