Re: Dumb "current transformer" questions

Jim Stewart <jstewart@xxxxxxxxxxx> wrote:

> Yes, assuming that you haven't exceeded the primary
> or secondary current ratings for the transformer.

Wouldn't a hall sensor do a better job?
I mean with all the square wave and changing frequency a current
transformer seems to be not the best choice.
And if he is in DC ...


Nick, just curious
--
Motor Modelle // Engine Models
http://www.motor-manufaktur.de
DIY-DRO -> YADRO <- Eigenbau-Digitalanzeige
.

Relevant Pages

  • Re: Locked Scanner?
    ... Check the transformer has the capacity for the scanner ... Transformer ratings are the core cost - and thus relabelled to ... provide easy margin for no additional cost by the manufacturer. ...
    (uk.comp.homebuilt)
  • Re: Mains Current Sensor Idea
    ... I was thinking of using a current transformer, ... An optocoupler. ... A hall sensor over a PCB trace. ... Isn't 10ma too small for the Hall sensor? ...
    (sci.electronics.design)
  • Re: 3-phase from DC converter?
    ... >less than the wattage of your load, since power ratings would be ... The current ratings of the transformer would have to be unchanged - ...
    (sci.electronics.design)
  • Re: Need a big transformer...
    ... In article, I, Don Klipstein wrote: ... VA ratings that I said there need to be increased by 41% if you make any ... use of transformer windings working in halfwave mode. ...
    (sci.electronics.basics)
  • Re: Dumb "current transformer" questions
    ... or secondary current ratings for the transformer. ... Wouldn't a hall sensor do a better job? ... I mean with all the square wave and changing frequency a current ...
    (rec.crafts.metalworking)