Re: Attach Rotary Table Vertically to Mini-Lathe?
- From: Richard J Kinch <kinch@xxxxxxxxxxx>
- Date: Thu, 29 Sep 2005 18:20:38 -0500
Rex B writes:
> The indexer has enough axial travel that you could
> use that instead of carriage travel to feed the work, for many
> applications including that of the OP.
Not the cheap Enco one.
.
- References:
- Attach Rotary Table Vertically to Mini-Lathe?
- From: KN
- Re: Attach Rotary Table Vertically to Mini-Lathe?
- From: Richard J Kinch
- Attach Rotary Table Vertically to Mini-Lathe?
- Prev by Date: Re: Cutting a shaft off a motor
- Next by Date: Re: Attach Rotary Table Vertically to Mini-Lathe?
- Previous by thread: Re: Attach Rotary Table Vertically to Mini-Lathe?
- Next by thread: Re: Attach Rotary Table Vertically to Mini-Lathe?
- Index(es):
