Re: gap space on Barley Crusher
- From: buck <Earlb4@xxxxxxx>
- Date: Sun, 13 Apr 2008 08:45:08 -0700 (PDT)
On Apr 11, 1:38 pm, "beerboyfeelgood" <richkevnos...@xxxxxxxxxxxxx>
wrote:
I just received my new Barley Crusher and am ready to do some damage. One
question for anyone who has used the BC: where should I start with the
spacing on the rollers? The instructions say that the gap is set "at .039
thousands of an inch at assembly". I understand the need to prevent stuck
sparges, etc., but in the interest of saving grain, is this a good place to
start?
kev
I found my marks to be .045. Do find need to change it for wheat or
send it thru a second time.
.
- Follow-Ups:
- Re: gap space on Barley Crusher
- From: HiRoller
- Re: gap space on Barley Crusher
- References:
- gap space on Barley Crusher
- From: beerboyfeelgood
- gap space on Barley Crusher
- Prev by Date: Re: Who is entering the NHC and what type did you submit?
- Next by Date: Re: Adapto Flange
- Previous by thread: Re: gap space on Barley Crusher
- Next by thread: Re: gap space on Barley Crusher
- Index(es):
Relevant Pages
|
