Re: OMC Cobra trim problem

Tim wrote:
On Sep 10, 7:10 pm, jim <mo...@xxxxxxxxx> wrote:
Larry W wrote:
The trim on this boat will not go up or down. I've checked the power
feeds and grounds and they are fine but all I get are clicks at the part
pictured below.
This looks a little different from the trim solenoids I've replaced in
the past but I'm assuming it's just a sealed unit that does the same thing.
Does anyone know the name of this part?
Do these things commonly fail? I'm having a hard time finding the part
on the internet.
Can I test the pump by bypassing this part - the pump has a Blue and
Green wire going to it.
http://www.rovatune.com/trimsolenoid.jpg
Thanks for any help
Larry
Touch 12V to the blue lead the pump should activate and the drive moves
up. 12V to green should make the drive go down. That thing with the
circuit breaker might be a combo device with solenoids and breaker.
You'll figure it out.

OOPS! Hit too soon.

the pump motor , that is if it's a magnet field motor. your two wires
go to the brushes Possible to put positive on one wire, and neg. to
the other. Motor should run one direction, change the polarity and it
will run the other direction. That rule usually applies to magnet
motors though. Like an automotive window motor

Tim,

I was wondering where/how the motor was grounded but if you're correct, that would make sense that there are just 2 wires and no obvious ground.

I'm going to test it in the morning but I wonder if I can do any damage testing it like you describe.

The part I attached a photo of is called the Relay and Circuit Breaker Assembly and cost close to $300. If the trim pump motor tests OK then the Relay Assembly must be bad.

I'm learning that boats are like cars - sort of.

Thanks for your help
Larry

.

Relevant Pages

  • Re: Fixing well producing lots of sand?
    ... The depth of water level is ... I assume that you have a submersible pump. ... Well depth is not sufficient to determine pump motor size. ...
    (misc.survivalism)
  • Re: Well pressure switch only shuts off one side of line
    ... > the pressure switch and then all you'd need is a double pose-single ... Why whats the neutral for and where on the pump do you connect this ... 120 not needed or used so run the wire then wire nut it at the pump?? ... > just get one rated for "motor starting", for the size of your pump motor. ...
    (alt.home.repair)
  • Re: OMC Cobra trim problem
    ... Can I test the pump by bypassing this part - the pump has a Blue and ... Green wire going to it. ... the pump motor, that is if it's a magnet field motor. ... If the trim pump motor tests OK then the ...
    (rec.boats)
  • Re: Knackered Visacreme pro machine
    ... I've stripped the machine down to discover how it works and seem to have tracked the problem down to either the pump or the motor. ... turning it seems to turn fine. ... mains from the board) to rule this in or out. ...
    (alt.coffee)
  • Re: Running compressor "too slowly"
    ... A pump that's used on a 5HP model may be the same one used on a 7.5HP model, with the 7.5HP model having a slighly larger motor pulley diameter. ... provide less air than the compressor is rated for, ...
    (rec.crafts.metalworking)