Re: Mercruiser Carb Conversion


<PhantMan@xxxxxxxxxxxxxx> wrote in message news:9lru04hs9km4v20sr2phsu6o8mhrplqoge@xxxxxxxxxx
I've been following this thread from the start but, even though I've
owned several sterndrives over the years, I'm a bit lost with the
mounting probs and brackets etc. The engines in mine were just
converted auto engines with a belt driven water pump already bolted
onto the front of the block as per usual.

On Tue, 22 Apr 08, "jamesgangnc" wrote:
the original merc
outdrive really is the bottom half of an outboard and that's where they all
are on outboards.

But also keep in mind that the upper half is the bit that needs the
cooling and it's an "Inboard". None of which (straight inboards) need
an outboard type impeller. I've always wondered why the designers
didn't just get the cooling water through the bottom of the boat like
any normal straight inboard setup. One of the reasons I don't care for
sterndrives is it seems like they all have so many unnecessary
complexities designed into them. And cooling water intake is just one
of them. Maybe I'm missing something but what's the point in sucking
up water with the outdrive with all its additional parts and probs
when sucking it through a thru hull (like a zillion straight inboards)
would be so simple?

Rick

The Merc. small outdrive or any outboard water pump is immersed in water. No need to suck, just push. I suspect that the engineers felt it unnecessary to reinvent a proven design when they adapted an outboard lower to an inboard engine. Later when FWC and high HP engines came along they found the little outboard water pump couldn't deliver the needed volume of cooling water. Back to the drawing board for a new solution.

.

Relevant Pages

  • Re: Mercruiser Carb Conversion
    ... The engines in mine were just ... an outboard type impeller. ... didn't just get the cooling water through the bottom of the boat like ... when sucking it through a thru hull (like a zillion straight inboards) ...
    (rec.boats)
  • Re: Mercruiser Carb Conversion
    ... > an outboard type impeller. ... > didn't just get the cooling water through the bottom of the boat like ... > when sucking it through a thru hull (like a zillion straight inboards) ... small outdrive or any outboard water pump is immersed in water. ...
    (rec.boats)
  • Re: How bad is too bad?
    ... Cooling of internal combustion heat engines is most often ... atmosphere or water, as for instance with marine engines. ...
    (rec.bicycles.tech)
  • Re: [SLE] Warning to Americans!(now going OT)
    ... Splitting water into hydrogen and oxygen takes energy. ... The *only* reason that it's used in rocket engines is that it gives just about the best ISP possible for current technology in an engine that has enough thrust to get from sea level to orbit. ... An ICE burning H2 would have to use *twice* as much H2 as air, even if the air was pure oxygen -- with open air being largely N2, it's even worse. ...
    (SuSE)
  • Re: Water Fuel Rocket Science
    ... Water is an extremely compact form of the two chemicals, ... cars and engines of all sorts. ... How an internal combustion engine works. ... burn petrol/diesel/... ...
    (sci.space.shuttle)
Loading