Re: Minn Kota Trolling Motor Problem

gjsmo <gabjsmo0@xxxxxxxxx> wrote in news:f00b7039-ba96-4953-8b5a-
a6488bf3a30d@xxxxxxxxxxxxxxxxxxxxxxxxxxxx:

I have a 28 Lb thrust Minn Kota Powerdrive. The motor that is used to
change direction appears to be bound up. The motor that runs the prop
works just fine. I am looking for a replacement that I would install
or someone that has access to the motor and would install it. The
other possibility is to get a new foot switch - but where. Thanks for
the help. Mike


http://www.northlandmarine.com/MinnKotaQuickRef.htm

http://cgi.ebay.com/ebaymotors/minn-kota-35w-12-volt-28lb-electric-
trolling-motor-
boat_W0QQcmdZViewItemQQitemZ120441956213QQsspagenameZRSSQ3aBQ3aSRCHQ3aUSQ3a
101

HURRY, BID $60-65! NICE LOOKING REPLACEMENT...GOOD SELLER RATING.

You can't fix it for $60....dump it and bid!

You still have 55 minutes from right now before the sale closes!


--
-----
Larry

Noone will be safe until the last lawyer has been strangled by the entrails
of the last cleric.

.

Relevant Pages

  • Re: Needs repair/replacement for Trane XV90 furnace inducer motor
    ... replacement or repair. ... How much would it cost? ... voltage but the motor was not working,right? ... So should I just go ahead and buy the one and install myself? ...
    (alt.home.repair)
  • Re: Wiring for 230 volts electric motor for RUDD furnace
    ... The motor you got is not an exact ... replacement, and you are not qualified to install the new one. ... go to sell the house. ...
    (sci.electronics.basics)
  • Re: Where to mount outlet for Jacuzzi tub
    ... If the tub doesn't have a heater, ... There is not always a lot of space for servicing the motor if needed, ... I usually install the bond wire regardless because I ... and shall be terminated to the equipment grounding conductor of the ...
    (alt.home.repair)
  • Re: Where to mount outlet for Jacuzzi tub
    ... If the tub doesn't have a heater, ... There is not always a lot of space for servicing the motor if needed, ... I usually install the bond wire regardless because I ... acceptable method of connecting the bond wire to the grounding conductor. ...
    (alt.home.repair)
  • Re: Where to mount outlet for Jacuzzi tub
    ... If the tub doesn't have a heater, ... >> There is not always a lot of space for servicing the motor if needed,>> so I ... >> I advise my customers to install a heater which will maintain the water ... >> acceptable method of connecting the bond wire to the grounding>> conductor. ...
    (alt.home.repair)