Re: antenna alternatives for isolated stays?

"Steve Lusardi" <stevenospam@xxxxxxxxxx> wrote in news:gaf992$2tl$01$1
@news.t-online.com:

Larry,
Why would this antenna's radiation not be coupled to ground, as it is
so
close and in parallel alignment with the grounded stay?
Steve



By the way, the most powerful AM radio stations in America run 50,000
watt blowtorch transmitters that USED to be HUGE and use amazing amounts
of power, converting most of it into heat for the cooling ponds in the
yard.

Today's 50,000 watt transmitters are made by Harris. Instead of huge
tubes and city-sized power supplies, they use 48 of these tiny
transistor modules:

http://www.hawkins.pair.com/wabcnow/wabcn14.jpg

Notice the US quarter dollar coin to show the size of them.
The modules are digitally switched on and off by the audio waveform fed
to a control circuit and are over 95% efficient, like the switching
power supply in your desktop computer. To put 50,000 watts of serious
RF power on the antenna, one only needs 55,000 watts....not 130,000 to
180,000 watts of the old transmitters...from the greedy power company.

The transmitter is actually cooled with muffin fans like the one on the
back of your computer. The old transmitters had huge air blowers or
distilled water cooling systems to take away the awful waste heat.

Any US stations you hear in Germany have this transmitter, now....

Amazing technology....

These white fuses are just like the ones in your radios....nothing
special.

If a module fails, the red light lights up, the control computer ignores
it until the technician reaches into the OPERATING high power
transmitter and pulls out the bad module while it all stays on the air
and replaces it. Noone in their cars will ever hear it fail.

That module in the picture has 8 transistors (the little black tabs with
one screw on the copper heat sinks. It, by itself, puts out 1,500 WATTS
of RF power.... The cooling air blows through the little holes in the
copper heat sink... They run 500,000 hours between failures!

Not very impressive unless you're standing at the base of the tower
listening to the hissing of the high RF power across the massive
insulator:
http://www.hawkins.pair.com/wcbs_wfan/cbsfan_twr14.jpg
BOTH WCBS and WFAN in New York City transmit on 660 Khz and 880 Khz
through that little piece of copper tubing coming out of the tuning
house using some trickery of inductance and capacitance I tried to give
you a glimpse of earlier:





.

Relevant Pages

  • Re: antenna alternatives for isolated stays?
    ... of power, converting most of it into heat for the cooling ponds in the ... Today's 50,000 watt transmitters are made by Harris. ... 180,000 watts of the old transmitters...from the greedy power company. ... one screw on the copper heat sinks. ...
    (rec.boats.electronics)
  • Re: Home NAS
    ... Atom, however the VIA boards are lower power (but slower, not an issue ... in it and it sucks about 45 watts. ... sturdily made and had space to fit the extra two drives, using MoBo ... Whereas I was struggling to get write speeds up to 20MB/s about six ...
    (uk.comp.homebuilt)
  • Re: cheap low power base unit for server?
    ... Atom, however the VIA boards are lower power (but slower, not an issue ... in it and it sucks about 45 watts. ... the original145 watt mini ATX psu fitted in this ... sturdily made and had space to fit the extra two drives, using MoBo ...
    (uk.comp.os.linux)
  • Re: whats everyone building these days?
    ... :> When I see a transient involving a peak signal power of 3,000 watts, ... Better bring a power hacksaw and a lot of time. ... Tube amps do give a softer clip. ... :>> WE didn't use their own tubes for strictly technical reasons. ...
    (rec.audio.tubes)
  • Re: Heatsink fin area for given temp rise.
    ... The Quad is a Class B amplifier. ... Watts of Class A power. ... Which means having 32 watts in the heatsink at idle. ... I was merely correctly your misconception about fans. ...
    (rec.audio.tubes)