Re: Have new laptop I need to connect GPS

Mike,
I did exactly what you are talking about with my old compaq laptop and
a Raymarine tiller pilot on my Hughes 31. I use either Nobeltec or Fugawi as my mapping software. My Nobeltec is old and I can't afford to get the new version so I bought Fugawi 4 ECS which takes either the old BSB charts, the new ENC charts or several other maps. I purchased a GPS receiver that plugs into my USB port (cheap, $135.00 CDN) so requires no power except from the computer and run the auto pilot off my nine pin serial port. Only requires two wires, Pin 3 to NEMA data on the autopilot and Pin 5 to ground. The whole system works like a dream except that the Raymarine unit won't automatically follow a route. When you hit a waypoint you have to tell it to turn onto the next leg by pressing Nav or Track or +10 -10 depending on your unit. This I'm sure is planned on the part of Raymarine as your average recreational boater is an idiot and if they allowed for it to automatically follow a route somebody would put it on autopilot and go below for a beer. The largest majority of newer laptops don't seem to have a serial port and I don't know how the output will work with a USB to Serial converter. Before I found the USB GPS I tried several USB to Serial converters trying to get my old Lowrance GPS to interface with my computer before I finally found one that would work.
Ed Henderson


captmhunt@xxxxxxxxx wrote:
Hi All: I'm new to the group, but I do have a serious question.

In April I bought a new DELL XPS Laptop... great machine, but I'm not
doing a commercial here.! My problem is, I want to hang a GPS on one
of the inputs and, possible an autopilot on the output. I have a
Garmin handheld but will replace that with something that runs off boat
power and my old autopilot died a couple of years ago so that will be
replaced as part of this package replacement project.

Does anyone know a good place to go for recommendations or does anyone
on this group have any? I've already looked at the Garmin site but I
don't really know if that's where I want to go.

Any help or advice would be appreciated. Thanks

Mike

.

Relevant Pages

  • Re: Raymarine to Nauticast-B interface problem
    ... along with the Actisense NDC-4 to the Raymarine E120. ... Things work on my laptop, wired direct thru the serial port. ...
    (rec.boats.electronics)
  • Re: No serial ports
    ... alarm software is pretty "low end" in regards to the laptop it needs.... ... I have been looking for a new laptop, and almost bought one, until I ... realized that none of the ones I've seen have a serial port. ... panels and Silent Knight Fire panels. ...
    (alt.security.alarms)
  • Re: USB console or other alternatives
    ... A desktop Windows machine with a serial port, ... Now it would be a laptop ... From a standpoint of love, ...
    (freebsd-questions)
  • Re: No serial ports
    ... Personally, I only use a laptop that has a serial port, which means an older one. ... since the alarm software is pretty "low end" in regards to the laptop it needs.... ... I know there are serial port adapters, ... Bought it then went ah crap no Serial port, how can I download Napco panels and Silent Knight Fire panels. ...
    (alt.security.alarms)
  • Re: Serial to USB - software converter
    ... on the laptop to use that serial over TCP. ... I have did something similar once, except it wasn't a serial port but the ... then parse and executed the commands on the hardware. ... for opening a handle and configuring the serial port, 1 for sending data, ...
    (microsoft.public.vc.language)