Re: Autohelm 5000 Boat going in circles

Hi there..

Where is the rudder transducer located?
I would be pleased to take a couple resistance measurements

No schematics


thanks Glenn Strazds



<timquig@xxxxxxxxx> wrote in message
news:1148471690.009990.287360@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I haven't seen anything to confirm you have checked your rudder
reference transducer. If you haven't you should disconnect first and
then check for red to green of 5K ohms and green to blue of 0 to 5K
ohms for 0 to 360 degrees of rotation.



.

Relevant Pages

  • Re: TECH: Ohming out contacts
    ... Eventhough I ... Coils are only 3-4 ohms so the added resistance would ... Resistance measurements should only be made when the machine has power ...
    (rec.games.pinball)
  • Re: Attack From Mars Flipper Issue
    ... Jeremy - I did verify the wiring for flip/hold and in diagnostic mode, ... Plus they match the resistance measurements above 4 ohms ...
    (rec.games.pinball)
  • Re: repairing a multimeter: PM2412
    ... the ohms ranges need the battery. ... I needed schematics (how else to identify those burned out resistors). ...
    (sci.electronics.repair)
  • Re: Autohelm 5000 Boat going in circles
    ... I haven't seen anything to confirm you have checked your rudder ... reference transducer. ... If you haven't you should disconnect first and ... ohms for 0 to 360 degrees of rotation. ...
    (rec.boats.electronics)
  • Re: Quick ESR answer needed
    ... 50 ohms with risetime about 1.8 ns. ... If those manuals include schematics I would love one too. ... Humor. ...
    (sci.electronics.design)
Loading