Re: nmea - talkers - listeners and lessons learned.

On Sun, 20 Jul 2008 09:02:35 -0700 (PDT), Doug Miller
<dpcmiller@xxxxxxxxx> wrote:

On Jul 19, 10:38 am, Josh Assing <Xjo...@xxxxxxxxxxx> wrote:
The SR161 can be used to consolidate incoming NMEA positional data from a
GPS with the AIS NMEA data into a combined high-speed data stream on a
single serial port.

In that scenario there is no need for any multiplexer.

but how does it talk to other non-high speed nmea devices then?

Basically you can take any inbound NMEA data stream or combined
datastreams at 4800 and the SR161 will combine that data with the AIS
data and output the combine original and AIS data streams on a single
outbound port. It is only for inbound data. You can't have two way
communication to the original NMEA devices - just an inbound feed to
the AIS receiver from the NMEA data stream.


I found that neither of my navigation programs (Ozi Explorer and Tiki
Navigator) could handle the combined NMEA/AIS signal from the SR161 -
or more correctly, they couldn't be set to accept both NMEA and AIS on
the same serial port. I understand that some other nav programs will
accept the combined data.


--
Peter Bennett, VE7CEI
peterbb4 (at) interchange.ubc.ca
GPS and NMEA info: http://vancouver-webpages.com/peter
Vancouver Power Squadron: http://vancouver.powersquadron.ca
.

Relevant Pages

  • Re: Raymarine and third party equipment via NMEA gives problem
    ... | I try to connect AIS and my SIMRAD Dataline-X equipment (Depth, ... | Waterspeed and Wind) to my raymarine C80 via the NMEA port. ... | I have a multiple baud rate NMEA multiplexer (shipmodul-type minplex- ...
    (rec.boats.electronics)
  • Re: VHF with DSC & AIS output?
    ... nice option so I wouldn't need to install new antenna, buy AIS ... not a bunch of serial data sent at random like NMEA uses. ... requires the attention of the AIS receivers and synchronizing modems at all ...
    (rec.boats.electronics)
  • Re: Raymarine and third party equipment via NMEA gives problem
    ... | I try to connect AIS and my SIMRAD Dataline-X equipment (Depth, ... | Waterspeed and Wind) to my raymarine C80 via the NMEA port. ... | I have a multiple baud rate NMEA multiplexer (shipmodul-type minplex- ...
    (rec.boats.electronics)
  • Re: A question about NMEA, AIS and Raymarine
    ... our respective SR161 AIS receivers working and running with the several ... NMEA port on the Raymarine C80 chart-plotter. ... connection that I think, it is the VHF/DSC connection, which is NMEA ...
    (rec.boats.electronics)
  • Re: Do I need an NMEA multiplexer ?
    ... get the 4800 baud data into the NMEA port input on the s3 corepack but ... corepack into the c70 plotter. ... setting the AIS receiver to 4800 is not wise in areas ... The NMEA input on the autopilot does not recognize AIS sentances ...
    (rec.boats.electronics)