Re: Bilge Alarm Advice needed



"Bob" <freya2go@xxxxxxxxx> wrote in news:1140021985.976464.88870
@g43g2000cwa.googlegroups.com:

But the article
description mentioned some electrical magic that I do not understand.



These electronic-controlled pumps come on every few minutes to measure
motor current, which will be low if the pump is dry, but high if the pump
is underwater and DOESN'T cavitate madly. If the current is low, the
electronics shuts it back down until it times out again. Runs about 3
seconds if dry. Runs until the current shows a good drop indicating the
pump ran out of stuff to pump overboard if the initial current is high.

No magic, just an series small resistor to sense motor current and a custom
IC to monitor it, already programmed.

.



Relevant Pages

  • Re: Timer for Jabsco shower drain pump
    ... certainly talking about a flexible impellor pump that should not be ... "The pump can run dry for as long as the motor can run. ...
    (uk.rec.waterways)
  • Re: Regulating pump pressure
    ... | supplied to appliances with somewhat specific voltage and amperage ... Certainly true for electronics, and possibly for a rotary pump. ... |>>> pressure during the brewing processby regulating the electricity going ...
    (alt.coffee)
  • Re: Timer for Jabsco shower drain pump
    ... I've checked with Jabsco, their reply was: ... "The pump can run dry for as long as the motor can run. ...
    (uk.rec.waterways)
  • Re: Regulating pump pressure
    ... >Certainly true for electronics, and possibly for a rotary pump. ... running it on a slightly lower voltage would lengthen ... I have an old Dremel tool speed control out in the garage, ...
    (alt.coffee)
  • Re: Hydraulic press and load cells
    ... I don't understand your fear of electronics in combination whit fireworks. ... Besides the obvious hazard from sparks in the engine (that is too far away ... and so on) to calculate how much power needs to be fed into the pump motor. ... The pump motor power controller is, of course, located very close to the ...
    (rec.pyrotechnics)