Re: question of principle
- From: Ben C <spamspam@xxxxxxxxx>
- Date: Tue, 15 May 2007 02:56:06 -0500
On 2007-05-15, jim beam <spamvortex@xxxxxxxxxxxxxxx> wrote:
ok, let's see who's awake.
imagine i have a strip of extruded 6106 aluminum bar 1" wide 1/4" thick
and 12" long. it's unanodized and effectively free of surface defects.
then, imagine i machine a sharp 1/16" wide "v" notch in the middle of
the bar to a depth of 50% thickness. finally, i load the bar in 4-point
loading with the two outer load points 1/4" from the ends and the two
middle load points centered and 2" apart. the notch is on the tensile
side with respect to load.
now, at what stress will the bar yield? is it:
a. ~100% of un-notched strength?
b. <50% of un-notched strength?
c. er, don't know?
What's 4-point loading?
.
- Follow-Ups:
- Re: question of principle
- From: jim beam
- Re: question of principle
- From: datakoll@xxxxxxxxx
- Re: question of principle
- References:
- question of principle
- From: jim beam
- question of principle
- Prev by Date: Re: Whaddayacallem?
- Next by Date: Re: Time to eat my words!
- Previous by thread: Re: question of principle
- Next by thread: Re: question of principle
- Index(es):
Relevant Pages
|