Re: Help with adjusting front derailleur (triple)
- From: "Qui si parla Campagnolo" <peter@xxxxxxxxxxxx>
- Date: 8 Aug 2006 06:18:47 -0700
Bob in CT wrote:
On Sun, 06 Aug 2006 18:23:27 -0400, <lyee@xxxxxxxxxxxxxxxxxxxx> wrote:
Bob in CT wrote:
Should I just use this technique, or is there an easier way to do this?
It seems that I should not have this trouble, but every time I replace
the
cables/housings for the front derailleur, I seem to have the same
trouble
and wind up using the same jury-rigging technique.
--
Bob
Are you saying that you cannot get enough cable tension by using the
barrel adjuster on the downtube cable stop?
Leland
Yes, although I can try adjusting the barrel adjuster again tonight.
--
Bob in CT
Remember tightening the cable with the BA moves the FD and changes the
start position. It will help to make for clearance in big ring, small
cog but can also result in chain rub in small ring, biggest cog. The
'book' from shimano says the clearance should 0.0-0.5mm-that's is
really touching, chain to cage clearance in small ring and big cog.
.
- References:
- Help with adjusting front derailleur (triple)
- From: Bob in CT
- Re: Help with adjusting front derailleur (triple)
- From: lyee
- Re: Help with adjusting front derailleur (triple)
- From: Bob in CT
- Help with adjusting front derailleur (triple)
- Prev by Date: Re: How to swap an MTB threadless stem
- Next by Date: Re: Spoke Breakage Question
- Previous by thread: Re: Help with adjusting front derailleur (triple)
- Next by thread: Re: Help with adjusting front derailleur (triple)
- Index(es):
Relevant Pages
|
