Problem - loose cone/cup.

Threaded headset cups & cones; old french frame (LeJeune, I tink...).

Dia of the (bad) cone that fits tight measures 1.190; new cup is 1.182.

I could shim or loctite the new one, but is the 1.190 available?


.

Relevant Pages

  • Re: Homemade Carbide Lathe Toolholder
    ... between the shim and the steel tool ... holder. ... Prev by Date: ...
    (rec.crafts.metalworking)
  • Re: How to shim a neck...
    ... >There was a thread here ages ago about using plastic as a shim. ... but I guess high density stuff would be OK at a push. ... (Remove any digits from the addresses when mailing me.) ... Prev by Date: ...
    (uk.music.guitar)
  • Re: Problem - loose cone/cup.
    ... > I could shim or loctite the new one, ... Nevermind, did some research, the new one sems to be a JIS 30.0mm and what I ...
    (rec.bicycles.tech)
  • Re: Seat twist problem
    ... take an old biek tube and cut a little piece ... from that and use it to shim up the space involved. ... markf's Profile: http://www.unicyclist.com/profile/8102 ... Prev by Date: ...
    (rec.sport.unicycling)
  • Re: Tire changes - to do by oneself or hire out....
    ... Always use a torch when removing lugnuts from your motorhome then ... loctite when replacing? ... Prev by Date: ...
    (rec.motorcycles.dirt)
Loading