Re: holy smokes YouTube landing


<cherokee373Y@xxxxxxxxx> wrote in message
news:1183746810.680899.93560@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
On Jul 6, 8:56 am, "Bill Daniels" <bildan@comcast-dot-net> wrote:
Just idle fun speculation, of course. Clearly, a conventional rudder
like
the Genesis wouldn't work with a 31 meter span. But, it would take only
a
tiny amount of drag at the wing tip acting through a 15 meter moment arm
to
produce huge yaw moments. I've run this calculation a few times and the
net
drag of tip drag rudders would acutally be less than a conventional
rudder.
A trailing edge elevator would work fine regardless of the span. The
Genesis "T" tail is actually a hinderance.

As for the control moments to control engine thrust and "P" factors, yes,
that is a challenge. A few prople have suggested lowering the thrust
line
so it passes through the CG and aerodynamic center. The rear propeler
could
fold back somewhat like a Carat and be pulled into a tube in the rear
fuselage. Not sure how the landing gear would work with a low thrust
line.

Obviously there would be some weight reduction to the 'non lifting parts'
that would roll through the wing spar calculations allowing a lighter
wing.
Probably not a huge weight reduction but every bit helps the wing bending
moment.

Turning flight might be easier. The short fuselage could be kept aligned
with the local airflow easier than the very long one of the ETA.

Obviously, something like this isn't a 'cut and paste' sort of design.
Each
aspect of the design would break new ground and have to be carefully
thought
through. Each design change would affect everything else.

Bill Daniels

"Eric Greenwell" <flyguy...@xxxxxxxxxxxxx> wrote in message

news:nmkji.6642$wu5.6324@xxxxxxxxxxx



Bill Daniels wrote:
> I think this incident may have an influence on future designs. The
Genesis
obtains excellent handling and quite respectable performance without
a
tail boom which forces the question, " Why have one?" The 18 meter
and
larger gliders would obtain even greater relative performance and
damage
resistance since the fuselage size need not increase in porportion to
wing span.

I suspect the increase in wing span might still require a commensurate
increase in rudder/fin and boom length, just to control yaw, even it
wasn't needed for the elevator. Also, flapped gliders have relatively
less
drag from the elevator than aileron-only gliders, so I think they would
have still be better off because the wing could be more easily
optimized
for performance.

I wonder what the ETA would be like with the Genesis fuselage.

A further complication with the ETA is controlling the glider under
power.
I have no idea how it would work out in practice, but I'm guessing any
advantages of the Genesis type design would be lessened by the control
requirements under power. Add in the problems of stabilizing a floppy,
high-aspect ratio wing, and I'm willing to believe the nod for
performance
still goes to the conventional tail.

--
Eric Greenwell - Washington State, USA
* Change "netto" to "net" to email me directly
* "Transponders in Sailplanes"http://tinyurl.com/y739x4
* "A Guide to Self-launching Sailplane Operation"
atwww.motorglider.org- Hide quoted text -

- Show quoted text -

Bill,

Didnt one of the early flying wings use this for yaw control? small
spoilers at the tip of the wings. im imagining a long wing with a pod
on front and a boom back to just an elevator. sure would look cool

Most flying wings use some sort of wing tip drag rudder. The Genesis uses
"flippers" that move upwards at twice the rate of the ailerons. The B2 uses
split trailing edge drag rudders.

The stabilizer/elevator doesn't need the long boom at all. Placing the
elevators on the inboard wing trailing edge works very well.

Bill Daniels


.

Relevant Pages

  • Re: He-100 Part II- He P.1079 vs Me 509
    ... These Coefficient of Drag improvements were well within the ... An aircraft equiped with functioning surface cooling system is entirely ... transonic wing sections that reduce the rise in compressabillity drag. ... what its worth - my PhD was in 3D inverse aerodynamic design - I spent ...
    (rec.aviation.military)
  • Re: He-100 Part II- He P.1079 vs Me 509
    ... These Coefficient of Drag improvements were well within the ... Increasing the drag divergence Mach number with 0.05M is fairly easy to ... drag the change in aircraft cross sectional area needed to be gradual. ... into the wing, ...
    (rec.aviation.military)
  • Re: He-100 Part II- He P.1079 vs Me 509
    ... Increasing the drag divergence Mach number with 0.05M is fairly easy to ... speed in order to reduce the wing area, ... Drag falls of more rapidly so that piston aircraft are faster at higher ...
    (rec.aviation.military)
  • Re: holy smokes YouTube landing
    ... it would take only a tiny amount of drag at the wing tip acting through a 15 meter moment arm to produce huge yaw moments. ... The Genesis "T" tail is actually a hinderance. ...
    (rec.aviation.soaring)
  • Re: short field landings
    ... The Cub, ... The fat, symetrical wing helps too. ... High lift at low speeds generates induced drag, so increasing the lift coefficient of the wing helps you fly at a lower lift/drag ratio, which helps you slow down. ... Thus, flaps help. ...
    (rec.models.rc.air)
Loading