Re: Master Buss Bar?

I said that I much prefer what is called a barrier strip terminal block, and
whether you get it at The Shack, Mouser, Digikey, etc. is immaterial.

However, if you are going to roll your own, I prefer brass, as it corrodes a
lot less than either copper or aluminum.

Jim


"Morgans" <jjsmorgan@xxxxxxxxxxxxxxx> wrote in message
news:_KSzf.213$CJ3.139@xxxxxxxxxxx
>
> "RST Engineering" <jim@xxxxxxxxxxxxxxxxxx> wrote in message
> news:43c2$43cfdde7$425121dd$22336@xxxxxxxxxxxxxxxx
>> Conductivity for a hunk of metal 62 mils thick by quarter inch wide by a
>> foot long where you measure resistance in the micro-ohms means absolutely
>> nothing -- copper, brass, or aluminum. On the other hand, corrosion
>> means a lot -- like steel hardware on aluminum, no matter how good the
>> plating on the steel.
> \
> All good points. So, what is it that you are trying to say , in regards
> to which material should be used, and which to stay away from?
> --
> Jim in NC


.

Relevant Pages

  • Re: We can end it all right here
    ... > Jim wasn't being difficult, just responding to an 'inside' comment. ... Hello again, Hans ... found out they monitored the shack and had a half-hour chat in American Land ... used Land-Line Morse. ...
    (rec.radio.amateur.policy)
  • Re: PWM [or ANY OTHER] chip that can drive an H bridge?
    ... > I was going to suggest a 555, 50c for one at digikey. ... But if Jim is ... > Jeff Stout ... =:-O Very nasty electrical environment! ...
    (sci.electronics.design)
  • Re: who is at it AGAIN? ........
    ... Jim in the shack ... ... Are you sure its not just a technical problem, allowing you to post but not read via Virginmedia is hardly an effective way to restrict postings that are reported as offensive or a nuisance. ...
    (uk.radio.amateur)
  • Re: who is at it AGAIN? ........
    ... "Jim in the shack ..." ... 73 de Frank Turner-Smith G3VKI - mine's a pint. ...
    (uk.radio.amateur)
  • Re: PWM [or ANY OTHER] chip that can drive an H bridge?
    ... >I was going to suggest a 555, 50c for one at digikey. ... But if Jim is ... >Jeff Stout ... AND duty cycle requirements. ...
    (sci.electronics.design)