Re: Old one cylinder oiless tankless air compresser.


"Paul" <me@xxxxxx> wrote in message news:h8um42$leq$1@xxxxxxxxxxxxx
Capacitor is used as an aid in starting.
Once the motor is turning it has no affect.

That depends upon the motor... A RUN capacitor is engaged all the time on
some motors. A START capacitor may be required, as you say, to start
motors under load. Whatever the case, replacement of the capacitor(s) is
a fairly common situation and can be fairly inexpensive, compared to calling
out an electrician or buying a new unitl.

.

Relevant Pages

  • Re: Using Ultra Capacitors to Replace Batteries
    ... accept charge faster than a battery will.That's the only reason ... Depends on the load- if it's drawing constant power like a regulated ... SMPS with constant load (or a switching motor controller with constant ... Are DC motors constant power? ...
    (sci.electronics.design)
  • Re: Protection triac gated mains, on 600W power amp problem
    ... with universal motors for vacuum loaders. ... secondaries, increasing the rectified voltage to exceed normal ratings? ... A bad transformer can cause that. ... When doing a Lx check on the primary the Lx value should not exceed a value that would generate over the max expected load.. ...
    (sci.electronics.repair)
  • Re: 7.5 HP Lathe on a 10 HP idler?
    ... If the motors are in parallel then "line in" terminals A, B on the idler connect to ... terminals A, B of the load. ...
    (rec.crafts.metalworking)
  • Re: Mechanical drive source?
    ... It is the force utilized on anything other than driving your load. ... That will depend on the motor torque, ... I have automated agents for stepper motors on ebay, they are veery cheap, ...
    (comp.robotics.misc)
  • Motor speed stability
    ... The motors in a robot are not infintely powerful. ... torque to maintain a constant speed. ... Quick changes in the load which exceed the systems response time affect the ...
    (comp.robotics.misc)
Loading