Re: Small engine rebuild help/question

I am rebuilding an old cast iron Techumseh engine (The rod broke).
I am reassembling it, and at the bottom of the stroke I hear a sound.
Also at the top and bottom of the stroke there seems to be a slight
"play" where the rod does not move the piston any. Here is a video:
http://www.youtube.com/watch?v=WG_kcd9VV3Q
Is this a problem or am I being overly cautious? This is my first
rebuild and I wanted to get your opinion.
stryped.
___________________________________________________________________________­_

A worn or undersized wristpin would cause the noise and the sticking.
Rodan.
____________________________________________________________________________

It is a 4 cycle. The cover is removed. I installed the cam and the noise
is less pronounced. The noise is only at the bottom and top of
the stroke. Would an undersized wrist pin cause this? What sticking?
Will an undersized wrist pin be detrimental to the engine? This is
on a tiller that is only used in the summers.
stryped.
__________________________________________________________________________

A loose wrist pin will push the piston to the top of its stroke,
then leave the piston there until the moving wrist pin contacts
the bottom of its journal and begins to pull the piston down.
This makes the piston stay at the top of its stroke a short time
even though the wrist pin is moving down. The same thing
happens at the bottom of the stroke.

The thumping may be the loose wrist pin banging against
the top and bottom if its journal as it is pushed up and down.

I have no guess regarding how long the engine will last if the
wrist pin is worn or undersized and not replaced.

Good luck.

Rodan.

.

Relevant Pages

  • Re: Small engine rebuild help/question
    ... and at the bottom of the stroke I hear a sound. ... Will an undersized wrist pin be detrimental to the engine? ... A loose wrist pin will push the piston to the top of its stroke, ...
    (rec.autos.tech)
  • Re: Fast pedalling, why? Re: How many gears are enough?
    ... to pedals, and at anything above very low cadences, there is ... significant force applied to the pedals at the bottom of the ... pedal stroke and significant energy used in changing the ...
    (rec.bicycles.tech)
  • Re: Fast pedalling, why? Re: How many gears are enough?
    ... to pedals, and at anything above very low cadences, there is ... significant force applied to the pedals at the bottom of the ... pedal stroke and significant energy used in changing the ... The point is the muscular effort goes into the cranks while adding ...
    (rec.bicycles.tech)
  • Re: Can anybody identify this script?
    ... The vertical up-down stroke in the top element seems to start below the cross stroke. ... I tend to agree with Dyl's initial "gibberish" reaction. ... From top to bottom, possibly hooking at the bottom and possibly connecting to the top of the next vertical line. ...
    (sci.lang)
  • Re: Super Squish Pistons
    ... all pictures are of the bottom of the pistons. ... the only thing described is wrist pin height. ... On the "super ...
    (rec.autos.makers.vw.aircooled)