Re: What rear end gear??

On May 28, 9:38 am, cuhu...@xxxxxxxxx wrote:
A smaller diameter diff gear/ring gear would give you better miles per
gallon and probally slow you up a little bit getting off the mark.But,as
long as you enjoy blowing their doors off,why change it?
cuhulin

I agree, i tried a 4.56 posi once and a pair of 9" slicks and
shattered the whole thing hahahaha, prolly too much torque outta that
little motor. why is it called a mouse motor anyway i have heard
people call it that?

Brett

.

Relevant Pages

  • Re: No heat on passenger side
    ... >> the ac plenum box removed and the doors and or the motor must be ... and some the doors were stuck and burned up the motor. ... > It involves replacing the blend air door shaft. ... > Chrysler Tech ...
    (rec.autos.makers.chrysler)
  • Re: Power Window Motor removal
    ... I completed both drivers side doors. ... Now I have to remove the motor again as I did not install it ... at the right point along the guide as the motor gear teeth and guide ...
    (rec.autos.makers.ford.explorer)
  • Re: No heat on passenger side
    ... >>> the ac plenum box removed and the doors and or the motor must be ... > and some the doors were stuck and burned up the motor. ... >> It involves replacing the blend air door shaft. ... >> Chrysler Tech ...
    (rec.autos.makers.chrysler)
  • motor question
    ... I have this nice little 115v 60HZ motor which is rated 1/75th hp ... figure out how to hook it up without blowing it up. ... to try to determine a connection arrangement perhaps using an ohm ...
    (sci.electronics.repair)
Loading