Re: Turning Signal "Clicking" Won't Go Off

That would imply something is drawing power through it. The wiring
usually goes from the flasher right to the signal light switch. I also
think the hazard switch has a tag in there too.

I would be working that emergency flasher switch a few more times to see
if it gets better or changes again. They made a bunch of bad emergency
switches in the Jeeps of that age too so it would be my first suspect.

Mike

Cyke wrote:
>
> Yes the one I replaced was the one making the noise. I was able to
> remove the relay and the noise went away (of course, the turn signals
> didn't work at this point). However, when I replaced the module, I
> still had the same problem.
>
> David.
>
> Mike Romain wrote:
> > Is the one you changed, the one making the noise?
> >
> > Mike
> > 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
> > 88 Cherokee 235 BFG AT's
> > Canadian Off Road Trips Photos: Non members can still view!
> > Aug./05 http://www.imagestation.com/album/index.html?id=2120343242
> > (More Off Road album links at bottom of the view page)
> >
> > Cyke wrote:
> > >
> > > I was able to locate and replace the turn signal flasher relay. This
> > > did not fix the problem. The clicking still continues. I will try the
> > > battery cable thing this weekend. Thanks for all of your help so far
> > > and I hope you have a safe and happy holiday!
> > >
> > > David.
> > >
> > > gobroncos wrote:
> > > > Should be a little silver cannister or a little black box the size of a
> > > > quarter. While its clicking, give it a tap. If it stops, great,
> > > > otherwise, pull the neg Bat cable and wait 5 minutes then put Bat
> > > > cable back on. Jim
.

Relevant Pages

  • Re: quick emitter follower question
    ... transistor or JFET as a switch in place of the relay, ... There certainly will be noise added but not a lot. ... noise with weak signals, with larger signals the signal swamps out ...
    (sci.electronics.basics)
  • Re: Hum from Tube Distortion Pedal into clean amp
    ... by turning the B switch OFF, but not entirely or nearly enough (e.g. ... and one amp. ... ideas for using it to blend different signals with effects. ... After reading reviews on the different passive splitters and the ...
    (alt.guitar.amps)
  • Re: how do threads work?
    ... >> kernel for a little help, in the form of regular timer signals. ... it is signals. ... The kernel doesn't care if you switch stack causing such ... one CPU bound thrad and one I/O bound thread. ...
    (comp.os.linux.development.system)
  • Re: Analog switch configuration
    ... If I disconnect the inverting opamp and just directly connect the NO ... This still leaves the problem that pispaspos is switching a signal ... which means that all the switched signals must be no more than ... o/p switch just switches between the input and the inverted ...
    (sci.electronics.design)
  • Re: Need help with PLC noise problems in a Manhattan (New York City) apartment
    ... distinguish between your valid signals and external "noise" (i.e. a rose is ... > change as I switch branch breakers off. ... So when I switch the filter "off", ... >correct installation? ...
    (comp.home.automation)