Re: how to remove wipers on geo metro - help


<gregf@xxxxxxxx> wrote

> > >I need to replace the wipers on my 94 geo metro, but I can't figure out
> > > how to get the old ones off. There is some kind of bold, but no screws
> > > or anything that comes apart or off in any way. Does anyone have any
> > > idea?

> You're right, that's probably what it called, just 2 black studs on
> either side with no obvious way to remove them. it's attached to a
> small "box" that has what looks like a little lever, but moving the
> lever does nothing.

Sorry, but your description is not drawing a picture in my mind.

Are you trying to get the blades off the arms, or the arms off the shafts?

.

Relevant Pages

  • Re: Analysis of Dual Pivot Brake
    ... to give any sort of answer that is consistent with the fundamentals ... A freely pivoting 1:1 lever has forces on its ends ... Note that if the arms' point of contact lies on the line ... between pivots, then the numerator and denominator of this equation ...
    (rec.bicycles.tech)
  • Re: Can raised gold jewel setting be adjusted?
    ... is not totally flush with the surface of the bridge. ... The one that is actually touching is the one at the balance arm----I am think about bending the arm----OK? ... hmmm, do the arms look like they have been bent out, bending the arms will affect the timing, and also affect the poise unless you adjust both arms together and check the poise each time you adjust them ... if the arms have been bent out, are any of the screws filed down?, in other words the balance was a bit light and gaining too much so the arms were bent out to compensate. ...
    (alt.horology)
  • Re: shimano 105 front derailleur limit screws
    ... >> viewing the screws, even from below. ... where the screws exit and contact the stops on the arms. ... The 105 doesn't *have* any visible stops. ... The XT has everything enclosed in aluminum. ...
    (rec.bicycles.tech)
  • Re: Simplex Skewer(vintage) thread is? Or wingnut source ?
    ... The Jubilee long arms are useless. ... Do the shorts have the same long cable travel though? ... a lot of lever movement around the circle. ...
    (rec.bicycles.tech)
  • Re: Mounting 3rd Hard Drive XPS 410 & 9200
    ... You put all four screws into the drive, but a little loose. ... the face plate (simple pull down on the lever and it pops out. ... Just remove the drive panel, ...
    (alt.sys.pc-clone.dell)