Strange '97 Jetta 2.0 manual transmission problem



WHY???
I have seen 2 Jettas (1987 and 1997) both with 5 speed transmissions that
eat up the release bearings and the release rods.
Currently the 1997 is BACK at the transmission shop. It is a nightmare for
them, also owner, and even VW told them to just change the transmission.
They have changed the clutch, rod a few times along with the release
bearing, the rear housing of the transmission, both bushings for the rods
but the problem resurfaces after about 1 day of driving.

I am wondering if the transmission's mainshaft bearing is allowing some
tilting which might cause the release rod to spin all of the time with the
mainshaft and damage itself along with the release bearing.

BTW on that 1987 I changed out the transmission = no more problems which is
what I suggested to the 1997 owner!
I know of one good local VW transmission rebuilder, auto & man, but he was
busy at the time this problem occurred.

TIA
--
later,
(One out of many daves)



.



Relevant Pages

  • Re: Strange 97 Jetta 2.0 manual transmission problem
    ... So we are talking about the transmission mainshaft bearing and mainshaft ... the size of a dime that the rod presses up against. ...
    (rec.autos.makers.vw.watercooled)
  • Re: damnable power commander 3 vs 5 and dyno tuning and all that efi management BS
    ... Never understood why the Dyna got the 6 speed and other changes ... I bought mine after the transmission recall... ... My take on the inner primary bearing problem is that if you ... early in the model year promising free inner bearing replacement ...
    (rec.motorcycles)
  • Re: 96 toyota corrola high speed vibration
    ... Your Diff bearings are probably worn and require replacing, ... It's a well used car 313,500 miles. ... the spline going into the transfer case or transmission case. ... manual to replace this bearing and seal. ...
    (alt.autos.toyota)
  • Re: Strange 97 Jetta 2.0 manual transmission problem
    ... transmission shop is still fighting it! ... EVEN the dealer told the trans shop to replace the trans. ... Maybe they will inspect the main input shaft bearing. ... So now the bushing has to hold the rod centered. ...
    (rec.autos.makers.vw.watercooled)
  • Re: Connecting Rods
    ... Do not know what the load on your bearing will be. ... In automotive rods ... > a slight rod knock on one crank and no way to adjust for it. ... > like to put in "bearing" bronze inserts on the crank ends. ...
    (rec.crafts.metalworking)