Re: HELP!!!!

Not yet haven't got a gauge. Will try to get one. The only thing
otherwise that's confusing me is that I had put an MSD blaster 2 coil
in with a ballast resistor and at one point it would run and then when
we tried to accelerate it it died like it usually would and then
wouldn't start again. Got out my trusty old fluke 73 multimeter and
checked the voltage to the coil and it was only 4.7 volts. had 13 at
the batt. Then we changed it out for the old coil and it did the same
again. Thank goodness it's a long weekend and I have a bit of time to
look at it. I'm a plumber and haven't had a whole lot of time to get
around to it.

.

Relevant Pages

  • Re: Coil Calculations?
    ... I have a coil that is wound on a 1.125 inch diameter form and 3 inches ... I am trying to duplicate this coil only instead of using 11 gauge wire ... I am using 12 gauge aluminum wire. ...
    (rec.radio.amateur.homebrew)
  • Re: Help! Coil design?
    ... know how to specify a coil, and the engineers at the magnetics ... Exact wire gauge doesn't ... matter either, so I suggested 34 gauge or so, again, based ...
    (sci.electronics.design)
  • Re: Help! Coil design?
    ... know how to specify a coil, and the engineers at the magnetics ... Exact wire gauge doesn't ... matter either, so I suggested 34 gauge or so, again, based ...
    (sci.electronics.design)
  • Re: Stern Seawitch: Coil recommendations...
    ... AQ-26-600 would be just a fraction weaker, due to a higher resistance ... gauge and winding count for the hold portion of the coil. ...
    (rec.games.pinball)
  • Re: Help! Coil design?
    ... for my RFID project. ... know how to specify a coil, and the engineers at the magnetics ... matter either, so I suggested 34 gauge or so, again, based ... Can their machine handle the size, blah ...
    (sci.electronics.design)