Re: 94-97 how to replace front wheel stud? DIY?

On Aug 18, 2:00 pm, Dr0pZ0n3 <Dr0pZ0n3.2vj...@xxxxxxxxxxxxxxxxxx>
wrote:
those bolts should be cranked... not necessarily with an impact, but
cranked none-the-less. I think the torque spec is something like
100-115 lb/ft^2

--
Dr0pZ0n3

I know....but i was just trying to draw the stud into the plate. It
was turning when I tried to wrench it in with an open ended lug, so
some light impact action did the trick without holding anything else.

btw, is there a reason why some 3 leg puller won't work on that
circular plate pressed on the wheel hub?

-j

.

Relevant Pages

  • Re: Help adding header for A/C wall install
    ... bottom plate to directly support the A/C? ... header on a cripple attached to each side stud. ... For the A/C support I'd set another cripple and/or a 2' block fastened ...
    (rec.woodworking)
  • Re: Wiring a Shed
    ... However, if the runs go up to the top plate, I can't drill ... to the stud. ... I can't imagine there are so many or so large of screws there's not room ... enough for a hole large enough for a single run of Romex wherever it's ...
    (alt.home.repair)
  • Re: Horizontal studs
    ... If it's horizontal, it ain't a stud. ... I drilled through the plate from above, then up from the hole for ... was a piece of cake to hit the hole in the blocking. ... harder in an insulated wall (real hard with the cellulose fill I have). ...
    (alt.home.repair)
  • Re: Horizontal studs
    ... If it's horizontal, it ain't a stud. ... I drilled through the plate from above, then up from the hole for ... was a piece of cake to hit the hole in the blocking. ...
    (alt.home.repair)
  • Re: Wiring a Shed
    ... If that's the case, and I have to span several stud bays, what's the ... However, if the runs go up to the top plate, I can't drill ... through the stud near the top because of the screws holding the plate ...
    (alt.home.repair)