Re: Clutch noise problem

Greg wrote:
No, the clutch master cylinder has never been replaced--it probably
could use a fluid flush, though. Am I right about the possibilities
here? If it is the release bearing, I'd probably just have to wait
until I have a better reason to pull the transmission right? I guess I
am hoping it is something simple like re-greasing the connection
between the clutch slave cylinder and the release fork, or maybe
adjusting the clutch pedal. By the way, when the Helms manual just says
"grease", what kind of grease do they mean exactly?

the helm manual usually specifies. anything near dot3/4 hydraulics usually requires silicone.



TeGGeR® wrote:
"Greg" <centaur99@xxxxxxxxx> wrote in news:1156913516.118887.14850
@i3g2000cwc.googlegroups.com:

Hello- My 2000 Civic Si is makes a squeaking/chirping noise when the
engine is running. I can make the noise go away by putting a very small
amount of weight on the clutch pedal.
Has the clutch master cylinder been replaced recently?

--
TeGGeR®

The Unofficial Honda/Acura FAQ
www.tegger.com/hondafaq/

.

Relevant Pages

  • Re: Clutch noise problem
    ... could use a fluid flush, ... If it is the release bearing, ... between the clutch slave cylinder and the release fork, ... says "grease", what kind of grease do they mean exactly? ...
    (rec.autos.makers.honda)
  • Re: Help with greasing trailer wheel bearings
    ... You can't pack wheel bearings with a grease gun or a 'packet' of ... Put a glob of wheel bearing grease in the palm of your hand. ... Now slide the rotor or drum straight onto the spindle. ...
    (alt.home.repair)
  • Re: Repacking Crack Bearings
    ... Gives auto greasea no flow attitude on cycle bearing surfaces. ... moving relatively large amounts of grease in comparison to the ball ... the roller element is lubricated with the oil while the oil sits tight ... lubrication of the cooler running bicycle ball bearing effective. ...
    (rec.bicycles.tech)
  • Re: Bottom Bracket Adjustment
    ... > There's grease in there, ... If the bearing runs rough, ... Just about any oil with additive, ... Bottom brackets come in a range of qualities and your success with one set, and your lubrication regime no more proves its effectiveness than my 4 years as a bicycle mechanic without using your technique disproves it. ...
    (uk.rec.cycling)
  • Re: Repacking Crack Bearings
    ... "Grease" is not a naturally occuring substance or the result of some intuitive ... Rudge have always beeen lubricated by oil with success. ... not lubricate well at low speeds, ... Saturation of the grease with oil ensures that the bearing is well ...
    (rec.bicycles.tech)