Re: 87 crx si help!



the car was pretty f__ked up when my friend gave it to me and the
sticker wasnt there. i dont know anyone with a first gen crx in my
town... i might have to take a camera to a junkyard next time i roll
out there or try to peel one off if one out there has one.

thanks.

Grumpy AuContraire wrote:
I don't know about 1987 models but earlier models had a vacuum diagram
under the hood. My '83 Civic FE did not but luckily, someone else in
town had one that I was able to take pictures of it and other "under the
hood" documentation.

JT





dmihalko wrote:

i have a 87 si (fuel injected) that i have been trying to get on the
road for over a year as a project and now this little problem is making
me wanna rip out the hair that is left on my head.

it runs fine when i first start it. i recently put on a new throttle
body and fast idle control valve (from a junk yard since i broke my old
ones trying to clean them due to a hunting idle) in order to get this
thing to idle properly so i can get this thing inspected. I got it
idleing at 750rpm at operating temp, however once this this gets to
operating temp and i give it gas, it sometimes stalls immediately. I
have also recently put in new plugs/wires/cap/rotor/pcv valve and have
swapped map sensors so i dont think its that either..

I am fairly certain that i do not have any vaccum leaks, i cant hear
one with a piece of tube in my ear and searching, nor does carb cleaner
increase the idle when i spray it over the connections. after it
stalls, i have a hard time trying to get it to run again. normally i
have to wait for it to cool off for a bit.

There are some vacuum lines that have been capped off since i bought
it, but i have no idea where i can find a decent vaccum diagram online?

Can anyone send me in the right direction?? i cant seem to find any
info on this problem or where i can find a vaccum

thanks in advance,
-Dustin

.



Relevant Pages

  • Re: 2005 F-150 PCV Characteristics
    ... the fords have many places were a vacuum leak can start and cause the poor ... the use of bosch plugs are a big nono they fail easily ... hardly idle without stalling. ... I took the PCV out and really dont see ...
    (rec.autos.tech)
  • Re: 87 crx si help!
    ... I don't know about 1987 models but earlier models had a vacuum diagram ... hood" documentation. ... body and fast idle control valve (from a junk yard since i broke my old ... I am fairly certain that i do not have any vaccum leaks, ...
    (rec.autos.makers.honda)
  • Re: 87 crx si help!
    ... body and fast idle control valve (from a junk yard since i broke my old ... I am fairly certain that i do not have any vaccum leaks, i cant hear ... but i have no idea where i can find a decent vaccum diagram online? ...
    (rec.autos.makers.honda)
  • Re: 87 crx si help!
    ... body and fast idle control valve (from a junk yard since i broke my old ... operating temp and i give it gas, ... I am fairly certain that i do not have any vaccum leaks, i cant hear ...
    (rec.autos.makers.honda)
  • Re: Very low disk performance Highpoint 1820a
    ... The machine is idle only me doing the test via an ssh session. ... I really dont know what it could be driver issue? ...
    (freebsd-performance)