Re: We have ourselves a red hot SHIT HEAD folks

On Dec 5, 9:15 pm, cipher <nos...@xxxxxxxxxx> wrote:

so the manufacturer has agreed to ship it over to italy for extensive
repairs....but putting the resistors , soldering them back fixes it for
a while., then they become desoldered.


8 gets you 20 you don't get the same amp back.

Perhaps the same sheet-metal, but I suspect it will be otherwise
gutted almost entirely.

And as for shipping it back to Italy - that is mind-boggling. Their
local reps must be entirely clueless and/or know that something is
radically wrong or both and don't quite want to admit it.

Peter Wieck
Melrose Park, PA
.

Relevant Pages

  • Re: OpAmp Gain Values Revisited
    ... > Folks helped me with the first stage of a three stage audio circuit, ... > to be unity gain, so I asked about gain on stage one. ... using 10K resistors? ... and the National Semiconductor appnote was AN-31, "Op Amp Circuit ...
    (sci.electronics.basics)
  • Re: Phil PP self inverted
    ... :>: creates a 'small' version of the grid drive at the intersection. ... :>: That topology is similar to the amp I'm currently building except I'm ... could use some small 1 ohm resistors on the cathodes, ... so I'm using the typical two transistor CCS. ...
    (alt.guitar.amps)
  • Re: Yet another Peavey Classic 30 thread...
    ... Oh yeah, the power supply resistors *never* heat up enough to melt ... Too bad too the PCB is single sided which means cracks at solder ... what it takes to make a great amp. ...
    (alt.guitar.amps)
  • Re: Hardening a simple op-amp circuit against EMI
    ... inputs, right at the pins. ... for limiting the resistors at the input pins to "up to a few hundred ... The input impedance of an op amp can be seem as a high value resistor ... tends to appear on the output - more at high frequencies than at low ...
    (sci.electronics.design)
  • Re: El Kabong
    ... out the tone circuit, ... parts changed/upgraded are obvious - like blue flame proof resistors ... specifically about this amp? ... I'd suggest going to 1 watt carbon comps so the signal ...
    (alt.guitar.amps)