Re: Bose 201 Series II

In article <ADLFk.47601$De7.39503@xxxxxxxxxxxxxxxxxxxxxx>,
jakdedert <jakdedert@xxxxxxxxxxxxx> wrote:

I know, I know...but for $9 in good shape at the thrift store, I figured
I couldn't go wrong. No way to test, but the surrounds were in
excellent condition; so I figured at least the woofers alone were worth
$4.50 each.

Brought them home, hooked 'em up, they made noise...so far so good, but
where were the highs? AWOL...crap, blown tweets! Not so fast....

Tested the tweeters with 9v battery--fine. Okay, time to open the box.
Pulled the surprisingly flimsy woofer from the 1/2" MDF box In
addition to the minimal x-over components (resister and cap in series
with the tweeter) was a #561 automotive 'festoon' style lamp in series
with the tweet. Shorting that brought back highs.

Now considering this was a series limiter, should I replace it, or just
bypass? The lamp
<http://www.bulbtown.com/561_MINIATURE_BULB_RIGID_LOOP_BASE_p/561.htm>
is a roughly 12 watt unit with apprx. 1000 hours rated life. Did it
'fuse', or just wear out?

Strange stuff, this Bose....

jak

Light bulbs are surprisingly good current regulators. Small 12V 15W
bulbs have about 0.7 Ohms cold resistance and a current limit of about
1.2A. This and their slow changes in resistance makes them excellent
speaker protectors.

It's OK to bypass the bulb if the speakers aren't worth protecting. Or
you can just buy a pack of these bulbs at a hardware store for $1.
Since the lighting quality and life of the bulb doesn't matter one bit,
speakers usually have the very cheapest bulbs protecting them.

--
Google is a pro-spamming service. I will not see your reply if you use Google.
.

Relevant Pages

  • Re: Trivial question for electricians
    ... In the summer I work construction, ... electricians put in temporary lightbulbs, so we can see in the ... are regular 60w incandescent bulbs, like you'd see in a household ... If its resistance were to increase it would get dimmer, ...
    (sci.electronics.basics)
  • Re: Anyone know anything about electric heater wire
    ... > You would want to use them in series for greatest resistance - you ... > bathroom light bar and rewiring it in series with 6 100 watt bulbs. ... ohms total. ... Based on the _cold_ resistance you would need 4x100W bulbs in parallel to ...
    (alt.coffee)
  • Re: Anyone know anything about electric heater wire
    ... >> You would want to use them in series for greatest resistance - you ... >> bathroom light bar and rewiring it in series with 6 100 watt bulbs. ... > Based on the _cold_ resistance you would need 4x100W bulbs in parallel to ... > I suspect that you might need about 20 bulbs to get those 2.7 ohms. ...
    (alt.coffee)
  • Re: 300W Resistive load?
    ... I need a 300W load to test out my PFC. ... At 200V each bulb gets only 100V so the resistance will be a little ... just wanted to mention that because when at undervoltage the bulbs ... Lamps are easiest to hook up, perhaps three or more in series at first? ...
    (sci.electronics.design)
  • Re: 300W Resistive load?
    ... I need a 300W load to test out my PFC. ... At 200V each bulb gets only 100V so the resistance will be a little ... just wanted to mention that because when at undervoltage the bulbs ... connect a cold bulb to a running converter. ...
    (sci.electronics.design)